| EA-ED Shifter Handle Upgrade | |
|---|---|
Using the bolt cutters or the hacksaw cut a piece about 17cm long from the door rod round bar you got, then put it next to the selector bar you took out of your car and mark the spot you need to make a slight bend. To make the slight bend put the rod were you made the marking to bend on the corner of a workbench or put it in a bench vice and just push it till it starts to bend and that’s it your done, don’t bend it to much or it will not work when you put it together. Use a flat file or a bench grinder and de-bur both ends of the new selector bar. Now install the new selector bar short end in first, then screw the new EF/EL auto gear knob on almost down to the end now hold it firm and tighten up the locking nut using the shifter. Now you should have a nice working new auto gear knob that’s looks great. I have added some photos to help you with this mod I hope this helps    |
|
| Document Summary | |
| Document description: | Upgrading the EA-ED shifter handle to the EF/EL series type |
| Document written by: | BuNtEr on 29 2008>, Copyright © 2008 BuNtEr, all rights reserved. |
| Document revised: | 29 2008 - Revision 1.0 |
| Document views: | 13013 since 29 2008 |
|
|
|