|
| xhgazza |
|
||
|
Iv recently bought some blue LED dash lights and iv put them in and 2 didnt work...
so i swapped them around still didnt work!!!so i went 2 you-pull-it got some new light socket things.and used them. still not working!! its really pissing me off. can anybody help?
_________________ SL Kingsprings |
||
| Top | |
||
| OZBMX |
|
|||
|
Have you made sure you got them in correctly, don't forget leds, unlike globes, are polar sensitive, so you have to make sure you get positive/negative the right way around.
where are the two you put in that aren't working eg tacho etc.?
_________________ Signature removed by moderator.signature must not exceed 120x500 pixles |
|||
| Top | |
|||
| SLO247 |
|
||
|
as OZBMX has said, LED=Diode=one way for the current to flow. Pull out the two that arent working and turn them around.
|
||
| Top | |
||
| xhgazza |
|
||
|
yer iv swaped it around...
i dnt got enough fingers to count lol. its the area that does the fuel and R.P.M but it lights up white while the other side3 which is replaced is blue...
_________________ SL Kingsprings |
||
| Top | |
||
| mystro |
|
||
|
hey ive had the same drama over the last couple of days .
make sure you carefully wrap the pins round the led case and bend the bottom pins up so they make good contact . they are polarity sensitive , you will need a multimeter neg on pin 7 top row solderside(so you can see the lights) positve on pin 8 top row. if it doesnt work spin it round if it still doesnt bend the pins and try both combos again. |
||
| Top | |
||
| mystro |
|
||||
|
here
|
||||
| Top | |
||||
| mystro |
|
|||||
|
led when cant be as s ed soldering
|
|||||
| Top | |
|||||
| Who is online |
|---|
Users browsing this forum: I<3Falcons and 15 guests |
