Hi guys, I have recently taken my engine and transmission out of my AUII Falcon to replace the sump seal, rear engine seal, torque converter seal and the transmission sump seal. After putting everything back together I went to start the car and it immediatly stops unless I have the accelerator pressed in. once I let go of the accelerator it stalls. This sounds to me like its a throttle cable issue but cant seem to see any issues with it. When it does run, it runs rough also.

If anyone has any suggestions, it would be greatly appreciated.

Thanks heaps guys

Justin.

you plug the idle speed controller back in?
ontop of the throttle body

are the plug leads on correctly?