Hi everybody,
I have recent restored my au 1 ute I have installed all of the interior of a donor car ghia all internal wiring it all plugged together fine but apparently I also needed to change the engine bay wiring looms as well as the pin outs do not match although the plugs fit together fine I am sort of progressing with this I just have a few questions though my car is dedicated gas will a gas sub loom from a series 2 plug straight into the new engine bay wiring loom I also need to get the door looms as well do I need all the chassis wiring from the cab back too it has become very perplexing any advice will be greatly appreciated ...... Thanks Regards steve