Just purchased an AU2, drivers door won't lock with remote, doesn't sit flush when locked with key. Secondary locks work with fob, but when I attempt to lock drivers door, it pops up which is why I assume the horn fuse has been pulled. Is this a common problem? I tried searching to no avail.
Also one of the doors won't open from the outside, is this common aswell?
Thanks for any help.

I had a similar problem but I found it to be a mechanical problem, after installing new speakers in the front doors, I found the button that pops up and down above the door trim near the glass was sitting too low and whenever I tried to lock the car with the remote, the button in the door would pop up again. I found out by having the button mounted about 10-12mm off the door trim surface in the unlock position solved my problem, and when the car is in the 'lock' position, the button in the door would just sit flush. Hope this helps ya out.

But you still managed to lock the door with the key? Mine sits above the hole, not below when locked. A friend of mine thinks it might be an actuator