|
frankieh |
|
|||
|
Hi all,
In order to test some Cree LED headlights i had to remove the H4 block plugs from my loom.. The lights high/low didn't work in the default polarity so I had to swap the wiring around. (3 pin H4 plug) Now to go over the pits for my LPG inspection I had to by some good old halogen H4's to put in but I can't remember which wires go where of the 3.. I could probably work it out with a multimeter but I'm hoping someone can save me a heap of time by looking at the light plug and telling me the colours. many thanks, kindest regards frank |
|||
Top | |
TedW |
|
||
|
black = earth
brown = power to park light red/black = power to low beam green/orange = power to hi beam |
||
Top | |
frankieh |
|
|||
|
{USERNAME} wrote: black = earth brown = power to park light red/black = power to low beam green/orange = power to hi beam Yes thankyou kindly, but how does that relate to the pin config on the H4 plug? |_| which looks like the shape above only upside down. |
|||
Top | |
MAD |
|
|||
|
|
|||
Top | |
frankieh |
|
|||
|
Good to know.. thanks.. I would have guessed that the two parallel tabs were high and low and seperated by the common.. I woulda been wrong.
thanks again. |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 44 guests |