|
| Ctchme |
|
||
|
Hey guys, just wondering if anyone knows what wires are for what on front seats out of a BA xr6?
Thanks in advance
_________________ EFII Fairmont (XH00NR) - K & N apollo enclosed pod filter, Megasquirt 2 Ecu controlling fuel, 350 cc injectors flowed out 420cc, Walbro 255lph fuel pump, J3 chip with custom transmittion map, BA XR6 front seats. Turbo setup in the works. |
||
| Top | |
||
| TROYMAN |
|
||
|
there are a few things, power to the seat belt pre tensioner, power to the power base and wires to the seat airbag (if its from one with side airbags)..
|
||
| Top | |
||
| phatba |
|
||
|
if it has seat airbags, there will be a small yellow plug that connects to a holder at the base. if non airbag, there will be a plug with a loop of wire to close the circuit. from memory theres a black plug and a white plug aswell, one is for the motors to move the seat, and i think the other is the load sensor for the driver and passenger dash airbags....
|
||
| Top | |
||
| Ctchme |
|
||
|
{USERNAME} wrote: if it has seat airbags, there will be a small yellow plug that connects to a holder at the base. if non airbag, there will be a plug with a loop of wire to close the circuit. from memory theres a black plug and a white plug aswell, one is for the motors to move the seat, and i think the other is the load sensor for the driver and passenger dash airbags.... Thanks for the info, doesn't have seat airbags, will check them out tomorrow hopefully, would be mad if I can get the seat motor to work
_________________ EFII Fairmont (XH00NR) - K & N apollo enclosed pod filter, Megasquirt 2 Ecu controlling fuel, 350 cc injectors flowed out 420cc, Walbro 255lph fuel pump, J3 chip with custom transmittion map, BA XR6 front seats. Turbo setup in the works. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 45 guests |