|
TazzyFalc001 |
|
||
|
yo!
so, got an AU1.5, the upgraded one, and wanna know if its applicable to put an AU2 or 3 bcm in. its the forte model, and sick of the sh-t one in it Thanks!! |
||
Top | |
LOLHSV |
|
||
|
y are u sick of the s**t one it? whats s**t about your bcm, and why do think having a series 2 or 3 one in there will be better?
|
||
Top | |
TazzyFalc001 |
|
||
|
{USERNAME} wrote: y are u sick of the s**t one it? whats s**t about your bcm, and why do think having a series 2 or 3 one in there will be better? Im just looking to upgrade it, and upgrade most of the locking mechs anyway. |
||
Top | |
jasont |
|
|||
|
sorry for posting this here but could someone please explain to me what an AU1.5 is apart from the obvious that it is half way between AU1 and AU2. thanks
_________________ frankly my dear i dont give a damn |
|||
Top | |
Papa Smurf |
|
||
|
1.5= 01/06/99 to 29/02/2000, that is when Ford changed the Ignition switch to the later AUII/III type.
As far as fitting a later BCM, you can't. High Series BCM AU I Olive Drab in Colour from 98 to 31/05/1999 """" """""" """"" AU 1.5 Yellow in colour from 01/06/99 to 29/02/2000 """" """""" """"" AU II/III Pink in colour from 01/03/2000 to end. |
||
Top | |
jasont |
|
|||
|
thanks for the reply papa smurf, so that means that my AU which is an 06/99 Falcon 'S' comes under the AU 1.5.
_________________ frankly my dear i dont give a damn |
|||
Top | |
Papa Smurf |
|
||
|
{USERNAME} wrote: thanks for the reply papa smurf, so that means that my AU which is an 06/99 Falcon 'S' comes under the AU 1.5. Yes, your Ignition key should look like an AUII/III BA/BF type with the communication chip in the end of it. |
||
Top | |
jasont |
|
|||
|
yea the ignition key is the one you described, also just wondering in one of your previous messages you wrote
High Series BCM AU I Olive Drab in Colour from 98 to 31/05/1999 """" """""" """"" AU 1.5 Yellow in colour from 01/06/99 to 29/02/2000 """" """""" """"" AU II/III Pink in colour from 01/03/2000 to end. Does thaty mean that the BCM in my AU 'S' is a High Series one.
_________________ frankly my dear i dont give a damn |
|||
Top | |
Papa Smurf |
|
||
|
More than likely. The were used in nearly everything but Utes and poverty packs.
|
||
Top | |
jasont |
|
|||
|
so if that is the case then would i be able to transplant a complete dash i.e cluster, switches, climate control and under dash wiring harness from a fairmont and just plug and play as such or would there be some problems.
_________________ frankly my dear i dont give a damn |
|||
Top | |
Papa Smurf |
|
||
|
{USERNAME} wrote: so if that is the case then would i be able to transplant a complete dash i.e cluster, switches, climate control and under dash wiring harness from a Fairmont and just plug and play as such or would there be some problems. If you get the equivalent model it should be ok. Just remember if you are using the Fairmont centre dash part you will need a few things off the heater. As it stand, if you have a Tacho the change to a Fairmont style cluster would be straight swap without having to change the whole dash pad and wiring. |
||
Top | |
jasont |
|
|||
|
just wondering papa smurf how close would the au 1.5 and au 2 be i.e wiring schematics etc also was the mobile phone setup in the AU only for mid/high series or did the low series have them as well
_________________ frankly my dear i dont give a damn |
|||
Top | |
Papa Smurf |
|
||
|
{USERNAME} wrote: just wondering papa smurf how close would the au 1.5 and au 2 be i.e wiring schematics etc also was the mobile phone setup in the AU only for mid/high series or did the low series have them as well I have only seen the mobile phone cable in XR6, Ghia, Fairmont and Fairlane. Most wiring is similar EXCEPT the radio wiring. It IS similar but not same. |
||
Top | |
jasont |
|
|||
|
ok its just that i installed the factory cd player in yesterday and i have all the wires in the audio plug for the mobile phone setup to mute audio system etc
_________________ frankly my dear i dont give a damn |
|||
Top | |
aussiegwapo |
|
||
|
I have an au 8/99 with a gray BCM whats the difference with the others as its a ute ?
Have to replace the BCM due to problems with it not resetting to program the fobs and its coursing the locking moduls to jam in the drivers door when turning the key to unlock. |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 43 guests |