|
| bondy99 |
|
||
Age: 65 Posts: 1128 Joined: 13th Sep 2010 Ride: Ford Falcon AU 2000 Series II Location: Crestmead |
Hello again,
I am hopeful someone might provide me with a solution in fixing a minor problem. 2 days ago I had to use the Demister (Rearwindow) switch, the button pressed down ok and light shown + demister light shows up in dashboard. (Ford AUII) Whilst driving home, the light in the demister button failed to light up. however, the demister symbol in the dashboard remained lit until I depressed the demister switch to off. I'd like to have this switch working properly. Is this switch easy to remove i.e. to replace a burned bulb or is it a bit difficult? The switch is located on the facia holding aircon switch, radio and aircon control knobs. Any suggestions are welcome. Thanks |
||
| Top | |
||
| TimmyA |
|
|||
|
I did have one here when I was fiddling with my AU install... Pretty sure there was just a twist in globe in the buttons? Pop the AU centre fascia out and have a look see... Easiest way to find out...
Cheers, Tim
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| bondy99 |
|
||
Age: 65 Posts: 1128 Joined: 13th Sep 2010 Ride: Ford Falcon AU 2000 Series II Location: Crestmead |
@ TimmyA
Thanks for the quick reply. Is the Facia Panel easy to come off or is is tricky i.e. something I need to be weary or careful of? Thanks Peter |
||
| Top | |
||
| TimmyA |
|
|||
|
Ah yeah can't help you there... When I bought my AU bits it was separate from the dash already and I didn't look to see how it mounted...
Cheers, Tim
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| bondy99 |
|
||
Age: 65 Posts: 1128 Joined: 13th Sep 2010 Ride: Ford Falcon AU 2000 Series II Location: Crestmead |
TimmyA
No worries, I'll have a play with it, hopefully it wont crack when I remove it. Cheers |
||
| Top | |
||
| Esteven8 |
|
|||
|
Should have a twist in type globe on the top of the switch.
You can remove the switch panel (I'm assuming it's a base spec dash) by gently prying it off from the passenger side of the panel with a small flat blade screwdriver.
_________________ {USERNAME} wrote: Cheap pads squeal like cheap hookers, and you can take that to the bank. {DESCRIPTION} {DESCRIPTION} |
|||
| Top | |
|||
| bondy99 |
|
||
Age: 65 Posts: 1128 Joined: 13th Sep 2010 Ride: Ford Falcon AU 2000 Series II Location: Crestmead |
@ Esteven8
Thanks. I have not attempted to remove mine as yet but was looking at a spare I had from the wreckers. I was not sure if there was / is a bolt of screw holding the console insitu prior to prying off from the passenger side. Would Jaycar electronics have these globes or do I have to buy these from Ford directly? I have no idea what wattage these are but would be 12v I assume. |
||
| Top | |
||
| TimmyA |
|
|||
|
May as well replace it with an LED...
I'm pretty sure it's one of these type globes: http://www.ebay.com.au/itm/1-x-Neo-Wedg ... 19d67197fe Not sure which size but... I have fitted these to the heater controls in my ED and have never had one fail... Can't remember which size they are either now... Jaycar doesn't sell these and Ford probably do but I'd stick an LED in it if it were me... Cheers, Tim
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| bondy99 |
|
||
Age: 65 Posts: 1128 Joined: 13th Sep 2010 Ride: Ford Falcon AU 2000 Series II Location: Crestmead |
TimmyA,
Thanks for your help. I think LED might be the go. Does one need to have resistors for these to work or just plug in? Cheers |
||
| Top | |
||
| TROYMAN |
|
||
|
maybe im missing something, but au2 the demister switch/button don't light up just the icon on the cluster...
|
||
| Top | |
||
| TimmyA |
|
|||
|
Built in resistor bondy...
Troy... Maybe? Not sure... My Ed one does so I assumed the au one definitely would... Bondy may need to suss it out first... Cheers
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| TROYMAN |
|
||
|
my au demister button has no light... only the a/c button...
|
||
| Top | |
||
| 93EB |
|
|||
Age: 47 Posts: 2486 Joined: 6th Oct 2005 Ride: 93EB Fairmont / BA Falcon XR6T Location: Western Sydney |
On my dads AU Ghia the demister switch illuminates.
_________________ 93 EB II Fairmon8 with 17' EL GT's / Clear indicators / H.I.Ds / Sports exhaust / Lowered 2' / K&N / XR6 ECU. |
|||
| Top | |
|||
| TimmyA |
|
|||
|
Not blown is it troy?
The ghia dash is different from the base model isn't it? Different demister button because of the message centre? Cheers, Tim
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| TROYMAN |
|
||
|
no ill get a pic.... unless bondys is a series 1
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 26 guests |
