Hi has any1 got a ecu pinout diagram for a ea?? It would be much valued, cheers

EA Series 1 - ECU
PIN wire colour Description
1 yellow Keep Alive Memory Power
3 white Vehicle Speed Sensor
5 red/green Key Power - B+ when igntion is switched on
6 yellow Power Steering Pressure Switch
7 greeen/yellow Engine Coolant Temperature sensor
10 blue Air Con Clutch Relay
16 black Ingition Ground
17 white/black Self test output
21 grey/white Idle Speed Control Device
22 brown/green Fuel Pump Relay or circuit
25 yellow/red Air Charge Temp
26 orange/black Sensor Volatge Ref
29 green/blue Heated Exhaust Gas Oxygen sensor
30 orange/black Neutral Drive switch
31 yellow/blue Canister Purge enable output
34 green/yellow Serial Data Output Port (Link) TRIP Comp
36 yellow/green Spark Output from the EEC IV
37 red Vehicle power B+
40 black/green Vehicle ground battery negative (-)
45 blue/yellow Manifold Absolute Pressure
46 black/white Zero ref for most sensors
47 green/black Throttle Position Sensor Voltage
48 white/red Self Test Input
49 grey/blue Heated Exhaust Gas Oxygen sensor GND
56 brown Profile Ignition Pulse
57 red Vehicle power B+
58 dark brown bank 1
59 green bank 2
60 black/green Vehicle ground battery negative (-)

or look in resources..
documents.php?d=41

Hey good1 mate for the pinout,,,, Would u know how many pins on plug that goes in the tfi should have power???

One of the red ones should have power with the key on and the other red one should have power with the key held on start... One is ground, one is pip, one is spout and one is coil-

Cheers,
Tim

So there is only 2 power wires??

Yes as I said above...

Pip
Spout
Power
Crank
Coil-
Ground

6 wires and three into the internal module are

Pip in
Pip out
Ground

Cheers,
Tim