|
Tony.tolu |
|
||
|
Hi all new to your website I hope I posted this in the right spot, recently purchased a bf xr6 the car has an after market pioneer radio I lost power to the radio checked fuses nothing blown removed wiring harness from behind stereo , wiring was a little bodgy accessories was wired into the 12v power jack as well as the negative .The constant power wire had no current .In my search to trace wires I removed the icc , the constant power was wired up up under the dash had difficulties seeing were it went to , as it had no power I taped it up an decided to run a new constant power wire from the battery with it own fuse. Wired it all up stereo worked great however I have lost central locking passenger side checked fuses disconnected each wire individually while checking central locking process of ilimination stil nothing ( when I had icc out, I wanted to see if the car would start with out it could this have caused a fault?[code][/code] ) any advice would be greatly appreciated .
|
||
Top | |
TedW |
|
||
|
{USERNAME} wrote: Hi all new to your website I hope I posted this in the right spot, recently purchased a bf xr6 the car has an after market pioneer radio I lost power to the radio checked fuses nothing blown removed wiring harness from behind stereo , wiring was a little bodgy accessories was wired into the 12v power jack as well as the negative .The constant power wire had no current .In my search to trace wires I removed the icc , the constant power was wired up up under the dash had difficulties seeing were it went to , as it had no power I taped it up an decided to run a new constant power wire from the battery with it own fuse. Wired it all up stereo worked great however I have lost central locking passenger side checked fuses disconnected each wire individually while checking central locking process of ilimination stil nothing ( when I had icc out, I wanted to see if the car would start with out it could this have caused a fault?[code][/code] ) any advice would be greatly appreciated . fault codes have no effect on door lock - door locks feed from BEM below ICC if a sedan or wagon drivers door circuit is seperate to other 3 door circuits which are wired together - possible door actuator fault or wiring put a test light across red/yellow and yellow/black wire at actuator -should light when locking and unlocking if only 1 of the other 3 doors is faulty and no test light operation trace circuit from bem to door that is faulty- if passenger front -start at main connector behind left kick panel and connector above this that goes into door motor wires are red/yellow and yellow/black which feed power and earth to motor changes around depending o lock or unlock black = earth white/red = ajar switch |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 10 guests |