Hi every one. I have put a BA 6 into a speedway car and going to run the std ecu have made most of the loom just need to wier in the obd2 plug so u can get the ecu unlocked and then have the car dynoed.... but im a bit lost as to how to do the plug... if anyone could help or had a diagram would be much appreciated

Thanks james

should be same as BF
what are you fitting as far as dash as this is the other end of the bus circuit to enable it to operate correctly...........120 ohms here and same at ECU to give you 60 ohms in bus circuit (pink -blue and brown - yellow wires)