Fordmods Logo

SAAS 52mm Temp Gauge/Fan controller review 

 

Page 1 of 1 [ 2 posts ] 

 
 Post subject: SAAS 52mm Temp Gauge/Fan controller review
Posted: Thu Dec 10, 2015 1:48 am 
EFI Guru
Offline

Age: 59

Posts: 4359

Joined: 5th Nov 2004

Gallery: 28 images

Ride: 351 Vogue,XH 5.0,'17 5.0 Stang

Location: Perth
WA, Australia

Ok I bought one of these to control the fans because I've had trouble with pin 41 of the EECIV losing control of the fans on my 351 powered range rover which has EL fans.

This thing works but, because i didn't have time to research it properly before buying, I'm paying the price now.
As I said it works at controlling the fans but it has several problems.

1. You can set the switch-on point easily using the buttons on the gauge but, there's no hysteresis adjustment.

2. There's a separate relay box for controlling the fan which would be ok except it's not weather proof which means a fat power lead needs to run inside the car and back out again to power the fans!? Dumb!
So I modified the circuit board to just switch the low side of the EL fan relays.
Another stupid part of this relay box is that they could have sensed the power was going to the fans but instead the "ON" led just shows that the gauge has switched it on.....doesn't mean the fans are actually running

3. The digital display is bright white and not dimmable!? So you actually have to cover it up at night because you can't see the road!?

4. The back light of the display has changeable colours but it's pointless for a couple of reasons; first, the ultra bright digital display means it's pretty hard to see it anyway and worse, IT DOESN'T STAY WHERE YOU SET IT!?!!! Turn the engine off and it goes back to the original colour every time! WTF!?
Top
 Profile  
 
 
 Post subject: Re: SAAS 52mm Temp Gauge/Fan controller review
Posted: Thu Dec 10, 2015 7:54 am 
Getting Side Ways
Offline

Posts: 496

Joined: 14th Sep 2011

Ride: BF II Gas Ute

Location: Canberra
ACT, Australia

Hello,

I would use a capillary tube switch, and have an over-ride and disable for water crossings. A viscous coupled fan is better IMO because they can move a lot of air. Low speed / range with a lot of drag such as climbing a sand hill, you will need as much air as you can get through it. I like to keep things simple, less to go wrong a long way from home and easier to fix.

You could set up 2 Capillary switch's 1 to turn Fans on and the other to turn them off. The Aircon also needs the Fans, so a few things will need to be planned for. Nealy 40 years ago I had a small truck with a thermo, I could normally drive to Sydney without the fan coming on. If it did, it wouldnt turn off. It seems that at Highway speed it was actually slowing down the normal air flow !

 

_________________

Regards 96ELGli

Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 2 posts ] 

Who is online

Users browsing this forum: No registered users and 30 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Mon Dec 23, 2024 7:43 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names