|
| TimmyA |
|
|||
|
Your link is dead... But yes I remember that... Will take all of 2 seconds to heat them up and bridge them... Either use a blob of solder to bridge or if you can't get it to take then about 5mm worth of wire strand to encourage the flow...
E series ones didn't have that disable... You already have it pulled apart to clean the connector so it wont take long to do...
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| Futuraclassic |
|
||
|
ok well thanks so much for everything. if theres not already a tech doc in here about doing it i may do one at the same time. you have been a wealth of knowledge, thanks
_________________ People hate the au series but i wouldnt have it any other way!!! |
||
| Top | |
||
| Futuraclassic |
|
||
|
that link to tiperformance said this
5. AU Series 1 only. If the top of your ECU looks like the top picture on the left (i.e. no black resistors between the circled solder pads), you will need to join the two J3 enable links on the back of the ECU. Clean the solder pads with sandpaper and then use two small pieces of wire to join each horizontal pair as in the bottom half of the image. Do not join the vertical pairs well heres what they were talking about  only on series one though, anyone had experirewnce with this
_________________ People hate the au series but i wouldnt have it any other way!!! |
||
| Top | |
||
| rhys.c |
|
||
|
MR CVE did mine for me, did only take him 2 minutes to do.
Youve got me to thank for Au Series 1 ECU's being programmable. Well partly. When I went for my first tune they didnt exist so MR CVE got onto Jason at tiper and within a week a code had been written with the AU1 parameters required. so now they are tuneable 
|
||
| Top | |
||
| Futuraclassic |
|
||
|
{USERNAME} wrote: MR CVE did mine for me, did only take him 2 minutes to do. Youve got me to thank for Au Series 1 ECU's being programmable. Well partly. When I went for my first tune they didnt exist so MR CVE got onto Jason at tiper and within a week a code had been written with the AU1 parameters required. so now they are tuneable well thankyou then lol
_________________ People hate the au series but i wouldnt have it any other way!!! |
||
| Top | |
||
| rhys.c |
|
||
|
not really trying to take the credit lol but its good that its now available. Even if im not suing it at the moment.
Have you soldered it up yet? |
||
| Top | |
||
| Futuraclassic |
|
||
|
chip hasnt arrived yet so no
_________________ People hate the au series but i wouldnt have it any other way!!! |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 33 guests |
