|
| stomper |
|
|||
|
I looked in the manual to see what the low coolant sensor wire is yellow and black. So i found the loom for the sensor.
Now i need to find out if the sensor wire is connect to the dash or not.If so its just a case of adding the globe and we are done. If not ill have to add the wire like we had to for the trip computer. Thanks to anyone for any input.
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
| Top | |
|||
| Holbrookau |
|
|||
|
This may help: http://www.fordmods.com/forums/viewtopic.php?t=28676
_________________ '94 EF GLI
|
|||
| Top | |
|||
| stomper |
|
|||
|
LMAO. So its just a matter of putting the globe in and the sensor. Cheers.
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
| Top | |
|||
| Holbrookau |
|
|||
|
If the wiring shown in that thread is already in your car - then yes!
_________________ '94 EF GLI
|
|||
| Top | |
|||
| snap0964 |
|
|||
|
A word of caution: read my reply in this thread http://www.fordmods.com/forums/viewtopic.php?t=33080
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| stomper |
|
|||
|
snap0964 wrote: A word of caution: read my reply in this thread http://www.fordmods.com/forums/viewtopic.php?t=33080
OK. Now that i know that im going to go and get a fairmont cluster and a oil pressure s**t. Im almost tempted to do a fairmont mockup but i cant see a point getting all the front end stuff cause it will cost too much. I may get a venom bar.
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
| Top | |
|||
| Holbrookau |
|
|||
|
I have tested this and can confirm that NO other components are required in the EF GLi cluster to make the coolant sensor operational. Provided the wiring is correct, the sensor is OK and you have fitted the bulb, then it will work.
If you wish to test without draining the coolant, simply disconnect the sensor plug at the reservoir - the low coolant lamp will flash.
_________________ '94 EF GLI
|
|||
| Top | |
|||
| snap0964 |
|
|||
|
Yeah I should specify that some (not all) GLI clusters will need to have the extra components. It could be only applicable to EL GLI clusters, but as there have been a few circuit board revisions, later EF's may be the same - best way to check is as explained by adding the bulb and seeing if it flashes.
Myself and Itchone proved this about 18 months ago - IIRC the low washer light will be restored also on later revision boards.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| bazz |
|
||
|
ive got an ef cluster in my el and the low coolant light dont work .ive tryed to wire it up
|
||
| Top | |
||
| snap0964 |
|
|||
|
bazz wrote: ive got an ef cluster in my el and the low coolant light dont work .ive tryed to wire it up IIRC from your thread on this you tried a Fairmont cluster and it did work ???
http://www.fordmods.com/forums/viewtopic.php?t=33080
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| stomper |
|
|||
|
Im going to write a doco on this cause its s**t people. Need the sensor first.
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 18 guests |
