|
| tiny56 |
|
||
|
Wheres the easiest/best place to isolate the injectors on a EL
Which wire to cut for dual fuel install? |
||
| Top | |
||
| fordgt290 |
|
||
|
well u can do it any where between the ecu and infectors really, is it multipiont injection?
if it isnt then it will be easy one or 2 wires to splice into |
||
| Top | |
||
| 4.9 EF Futura |
|
|||
|
EL is multi point... but not sequential i believe.
So you probably need to disable the two banks independently. IIRC injectors operate by the ECU switching the earth on and off... Prob just get yourself a wiring diagram and shouldnt be too difficult...
_________________ I promise..... I will never die. |
|||
| Top | |
|||
| tiny56 |
|
||
|
ive got a haynes manual but it is vague and shows little detail but what i can see there appears to be a common feed from the TFI module to the injectors so i guess i can use that
|
||
| Top | |
||
| stockstandard |
|
|||
|
tiny56 wrote: ive got a haynes manual but it is vague and shows little detail but what i can see there appears to be a common feed from the TFI module to the injectors so i guess i can use that
Be careful with that. I havent looked at an EL loom, but the loom in earlier models supply 12V to all injectors and then have the earths switched via the ECU. There are a few other things that tap off the same 12V feed including the ISC. Just make sure you dont need any of the other stuff before you cut the wire.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| tiny56 |
|
||
|
yeah i saw that in the manual that it feeds other components i was gonna trace and cut close to the injectors so it is only the 12v supply to them
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 25 guests |
