hey guys. can someone please check this for me???
all ive done is change the RPM and speed limmit.
but for some reason the car doesnt seem to run right.
every now and then it will miss fire and vibrate badly untill i accelerate again
and there seems to be a buzzer noise comming from the injectors every now and then.
ive taken the J3 out for now but was wondering where i went wrong... maybe i changed something accidentally??

http://www.mediafire.com/file/polehq64cncjyoj/File1%20256k.bin (BIN file)
http://www.mediafire.com/file/yy51y3t8kmgnsu5/file1%20256k.xdf (XDF file)


if someone could help that would be great!

assuming the car is better when you remove the j3,
is the chip brand new? or was it on another car before?
check the connection, make sure its very clean, try putting it on again, duck taping it on hard.
they tend to get loose or dirty and cause problems

yeah the car runs perfectly once i have removed it. the chip is brand new, it seems to work well but after the 3rd start the problems start. ill give cleaning the terminals another shot. but other then that im guessing i stuffed up in the programming somewhere. this is all sorta new to me. so its a learning experience

Make sure you have a correct, matching bin/def for your car. Your filenames aren't reflective of the base files so can't tell if you've already done this.

Cheers,
Jason

im very sure its the matching codes. ill double check! thanks =)