|
| twase |
|
|||
|
I have a 3/8 steel fuel line that I have shortened and was trying to put brass olive connectors on without success. Can I just put the hose over the line and use a hose clamp to join it given its the supply line from the fuel pump and needs to handle at least 4Bar? Any other options?
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| TimmyA |
|
|||
|
olives wont seal... They're for copper pipe and such...
It needs some sort of double flare joiner (Maybe a brake place would have these)? And you'll need to double flare the end of the pipe which means the use of a special tool and you'll probably have to pull the pipe out depending on how well you can hang onto the tool... Other option is to at least get a single flare on it and use your hose clamp over proper fuel (not heater) hose then... You'd want some sort of risen edge to stop the hose sliding off... I have a brass barbed tee in my fuel hose which runs up to a connector so I can easily check my fuel pressure (and hence the health of my regulator) and used quality stainless hose clamps on it and it works fine... Cheers, Tim
_________________ 93 Red ED 5spd Manual Build Thread |
|||
| Top | |
|||
| snap0964 |
|
|||
|
TimmyA wrote: You'd want some sort of risen edge to stop the hose sliding off... Yeah, +1 to that.4 bar = 400 kpa = roughly 60 PSI ???
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| twase |
|
|||
|
Thanks guys, I had priced a double flare tool and that when I went and got the Olive seals.
Might do a single flare and use proper flare joints.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| twase |
|
|||
|
Ripped the steel lines out and purchased some anodised aluminium ones from Ebay.
Got the correct adapters from the same mob, all for an arm and a leg. At least now I can run them down the other side of the MAV where they now belong. Thanks for your help on this guys.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| XFWAGON |
|
|||
|
I'm too late. But you can get a fitting from Russell that attaches to the tube and has a male AN fitting. This is what I used for my fuel system.
_________________ 1993 LTD V8 Oregon 5 speed "click me" |
|||
| Top | |
|||
| twase |
|
|||
|
Have not installed the lines as yet but the fittings I have are brass olive to a hose barb.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 11 guests |
