|
| eagleaus |
|
||
|
Got a problem with my GAS.It does not seem to want to idle on gas.It runs down the highway on gas no problems but if it has to idle like using no throttle it will stall.No good when it stalls going around a corner and you loose power steering
 . The car runs and idles ok on fuel so I do not know what to think?Could it be a gas quality issue as I am getting my gas from a different servo at the moment.
|
||
| Top | |
||
| Waggin |
|
|||
|
There is an idle mixture screw to adjust the mixture for. (wait for it) idle!
Also check your base idle settings and check for vacuum leaks/vapour leaks The other thing to check is the balance hose. If your converter has a balance hose, make sure its connected correctly (usually to the lower airbox). Cheers
_________________ WAG363: AUII LTD Supercharged 363 Dart Stroker [Supercharged 363 LTD Build] |
|||
| Top | |
|||
| eagleaus |
|
||
|
Where's this mixture screw, I have looked at the Tickford converter and can not see anything that looks like I can adjust?? It all idles ok on petrol, it's just the gas idle.There may be a blockage.Would I be right in saying that there could be a idle circuit and a another separate circuit for cruising etc., I will look at those others things you mentioned.Thanks
|
||
| Top | |
||
| snap0964 |
|
|||
|
eagleaus wrote: Where's this mixture screw Have a look on the mixer, which is in your intake to the throttle body.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| eagleaus |
|
||
|
The Tickford mixer/converter is one unit and there is only two electric solenoids?? and a brass nut etc.,
|
||
| Top | |
||
| snap0964 |
|
|||
|
eagleaus wrote: The Tickford mixer/converter is one unit and there is only two electric solenoids?? and a brass nut etc., I'm only familiar with aftermarket units such as Impco, I would've thought regardless of the system, the adjuster (usually a spring loaded large screw) should be there somewhere - If no one else can advise you here, PM twason (Tony) - he knows the Tickford LPG setup pretty well.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| Waggin |
|
|||
|
I dont think the Vialle system has an idle mixture adjustment. On something like an Airrod this screw is on the converter.
Being a Vialle system it does have a balance hose, so double check that this goes to the unfiltered side of your airbox.
_________________ WAG363: AUII LTD Supercharged 363 Dart Stroker [Supercharged 363 LTD Build] |
|||
| Top | |
|||
| Bug |
|
|||
|
Check your PCV valve aswell, if its plastic u might have killed it with a backfire. My gas idle was messy until I replaced it.
_________________ EL XR6 5spd |
|||
| Top | |
|||
| eagleaus |
|
||
|
Replaced that as the bl**dy thing broke when i was checking it as well as the bl**dy groment split in half and the bottom half fell inside which i had to fish out. arrrrrrrrrrrrrrrr
|
||
| Top | |
||
| snap0964 |
|
|||
|
If your vehicle is LPG, you should ditch the plastic PCV and replace it with a metal one as a matter of course - most conversions usually already do this, but not all. There's been a post on here about this - if your car backfires and f**k the plastic PCV - the guts of the thing can do some serious damage to the valvetrain and to the timing chain area. I've seen the results on an LPG ED, and it aint pretty . . . .
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| eagleaus |
|
||
|
Not a problem, mine had a metal PCV valve and I replaced it with a metal one.Strangely inside the PCV hose it also have a brass restrictor with a hole on it.Looks like its always been there.Most likely it would stop the full blast of a backfire hitting the PCV valve and I have had the hose blow of once.
|
||
| Top | |
||
| Disco Frank |
|
|||
|
remove the intake snorkel....
dont know why but this works on heaps of taxis with the same problem.. only thing is... it sucks hot air 
_________________ RIP SCOTT |
|||
| Top | |
|||
| eagleaus |
|
||
|
Took it to ford Wednesday and all is normal.This is what they said they did (Clean LPG idle jet drain LPG convertor perform stepper motor reset road test check LPG starting now okay).Everything is now fine and going great guns
|
||
| Top | |
||
| ToranaGuy |
|
|||
|
eagleaus wrote: Took it to ford Wednesday and all is normal.This is what they said they did (Clean LPG idle jet drain LPG convertor perform stepper motor reset road test check LPG starting now okay).Everything is now fine and going great guns
That's a good thing. Let me guess, the converter is sitting verticle, instead of horizontal? My torana's is verticle, and every 25k kms it filles up with lotsa gunk in the bottom and runs like $hit. When i fit the new converters ( yes 2 ) for the turbo setup, they are going horizontal. Cheers ToranaGuy
_________________ I am the ToranaGuy!|74 Lh Torana Turbo|78 Hz PanelVan|86 Mighty Boy Ute|93 EB2 Ghia,GT Mockup,5spd,LPGI,Full Leather|2 x EB Xr8 5spd's|FS [VIC]: Wrecking - Eb XR8 - Parts available |Build Thread|Ebay Items - Ford Parts| |
|||
| Top | |
|||
| twase |
|
|||
|
ToranaGuy wrote: eagleaus wrote: Took it to ford Wednesday and all is normal.This is what they said they did (Clean LPG idle jet drain LPG convertor perform stepper motor reset road test check LPG starting now okay).Everything is now fine and going great guns That's a good thing. Let me guess, the converter is sitting verticle, instead of horizontal? My torana's is verticle, and every 25k kms it filles up with lotsa gunk in the bottom and runs like $hit. When i fit the new converters ( yes 2 ) for the turbo setup, they are going horizontal. Cheers ToranaGuy Eagleaus has the vialle convertor so its meant to sit verticle with the drain plug at the bottom. Cheers TW.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 21 guests |
