|
gotta luv a v8 |
|
|||
|
Will it make any difference if the Maf diameter is larger than the 70mm throttle body , also where would one find a good after market MAF & TB , thanks
_________________ Don't force it, use a Bigger hammer |
|||
Top | |
xafalcon |
|
||
|
MAF's are the most critical sensor on the V8 and you can't just slap any MAF on. It must have the same voltage:airflow that the factory MAF has. Or you need a chip programmed with the correct mass transfer data to suit a replacement MAF. Failure to follow these options will result in anything from non-optimal operation to engine destruction.
_________________ XA Faimont 351C, AU2 XR8 Manual 5.0, DA LTD 5.0, Mk1 Capri 5.0, 1995 Mustang 5.0, EF2 XR8 Manual, EF2 Fairmont Ghia 5.0, AU3 XR8 Auto, AU2 XR8 Auto, AU2 XR8 Manual Ute, TE Cortina 5.0 Manual, DU LTD 5.0 soon to be manual |
||
Top | |
gotta luv a v8 |
|
|||
|
So if I replace the 65mm TB with a 70mm one I should also replace the 65mm MAF with a 70mm and if I use the MAF sensor out of the 65 with a tune it would be ok ?
_________________ Don't force it, use a Bigger hammer |
|||
Top | |
xafalcon |
|
||
|
MAF size is determined by engine power - 55mm = 275HP, 73mm = 350HP, 80mm = 425HP. I am not aware of any commonly available 65mm MAF's???
_________________ XA Faimont 351C, AU2 XR8 Manual 5.0, DA LTD 5.0, Mk1 Capri 5.0, 1995 Mustang 5.0, EF2 XR8 Manual, EF2 Fairmont Ghia 5.0, AU3 XR8 Auto, AU2 XR8 Auto, AU2 XR8 Manual Ute, TE Cortina 5.0 Manual, DU LTD 5.0 soon to be manual |
||
Top | |
gotta luv a v8 |
|
|||
|
Your right I meant 70 & 75 got mixed up with the throttle body. I had a tune done and the tuner said I should fit a bigger maf then he would complete the tune and as I have a 70mm one so I figured a 75 would probably suit and a 70mm TB in place of the 65mm.
_________________ Don't force it, use a Bigger hammer |
|||
Top | |
gotta luv a v8 |
|
|||
|
Does engine HP determine the size of the throttle body?
_________________ Don't force it, use a Bigger hammer |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 29 guests |