|
Mitch_ |
|
|||
Posts: 6168 Joined: 5th Nov 2004 |
Waggin wrote: Go back a page and read for yourself
you know you could've just writen 130rwkw
_________________ |
|||
Top | |
Waggin |
|
|||
|
Well, 130 isnt the full answer Theres more to it.
_________________ WAG363: AUII LTD Supercharged 363 Dart Stroker [Supercharged 363 LTD Build] |
|||
Top | |
Mitch_ |
|
|||
Posts: 6168 Joined: 5th Nov 2004 |
so did u get higher figures than that :O
_________________ |
|||
Top | |
ReGiE |
|
|||
|
130 was the max for the night. and that was in 4th gear pulling only about 3500rpm
_________________ Gooooone - Eb2 Coon - 143RWKW |
|||
Top | |
Hyena |
|
|||
|
ReGiE wrote: 130 was the max for the night. and that was in 4th gear pulling only about 3500rpm And that's on a MDX dyno!
Did you run teh waggin on that dyno prior to fitting the Motec Brad ?.
_________________ |
|||
Top | |
Punnisher_42 |
|
|||
|
Waggin wrote: Yeh, not sure why they look purple.. but they were glowing the brightest red/orange you could imagine..
Was the flash on? Tends to do that to things that are glowing when the flash is on.
_________________ Regards, |
|||
Top | |
neil101 |
|
||
|
Can I ask what is MSII? and where do i find info on it?
Neil
_________________ HSV I JUST BEAT ONE !
|
||
Top | |
unclewoja |
|
||
|
neil101 wrote: Can I ask what is MSII? and where do i find info on it?
Neil MS-II is a DIY Ecu and info can be found here |
||
Top | |
Waggin |
|
|||
|
Hyena wrote: ReGiE wrote: 130 was the max for the night. and that was in 4th gear pulling only about 3500rpm And that's on a MDX dyno! Did you run teh waggin on that dyno prior to fitting the Motec Brad ?. Yeh.. previously she's run 109RWKW. Running so rich that the unburnt fuel was causing the AFR to read 16:1 Tip - Never run 24lb/hr injectors on an EEC in a 4L In other news, I exceeded 90% duty cycle on the injectors on the weekend. Grr.. need bigger injectors!
_________________ WAG363: AUII LTD Supercharged 363 Dart Stroker [Supercharged 363 LTD Build] |
|||
Top | |
4.9 EF Futura |
|
|||
|
Waggin wrote: Tip - Never run 24lb/hr injectors on an EEC in a 4L LMAO... i bet she idled a treat huh? Quote: In other news, I exceeded 90% duty cycle on the injectors on the weekend. Grr.. need bigger injectors!
Ouch. Was that WOT/high revs with a good afr? ...any scope to up fuel pressure? Better safe than sorry i suppose.... must be making impressive amounts of torque...
_________________ I promise..... I will never die. |
|||
Top | |
Waggin |
|
|||
|
running a bit lean at 5989rpm, WOT.
Using seat of the pants, you can definantly feel it dropping off power toward 6000rpm. I assumed it was just running out of breath, but it seems to be fuel related I'll probably just rev limit her at 5800rpm and wait til the turbo goes on, unless I can find some VERY cheap 32lb/hr injectors for the mean time.
_________________ WAG363: AUII LTD Supercharged 363 Dart Stroker [Supercharged 363 LTD Build] |
|||
Top | |
unclewoja |
|
||
|
Was it running lean, or were you getting a rich missfire?
Both will give you a lean reading. Rich missfire is like the name suggests. A missfire because the mixture's too rich. That gives you a lean reading because none of the fuel gets burnt so the exhaust fills with oxygen. Voila! There's you lean reading but you're actually running incredibly rich. Also, spark timing will have an effect on AFR. If the spark is too retarded and teh charge in teh cylinder doesn't have enough time to burn completely, it will give you a leaner reading. |
||
Top | |
Waggin |
|
|||
|
Rich Misfire would've best describe the condition. Thank god that is all a thing of the past now
_________________ WAG363: AUII LTD Supercharged 363 Dart Stroker [Supercharged 363 LTD Build] |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 27 guests |