|
pumpdogg |
|
||
|
Hi all, i have just bought an ef xr8. It came with no key fobs for the smartlock, so in order to start my car i flick the ignition to on the jump out and touch a wire to +12v away she goes. (sounds dodgy but ive done stolen checks and have receipts right back to original owner).
My question is if i get some fobs and program them in, am i then right to remove this wire and smartlock/central locking will work as normal, or is it not that simple. Any advice will be much appreciated. Thanks Justin
_________________ Let the xr8 collecting begin!!! |
||
Top | |
kevman |
|
||
|
You don't need the fobs to start the car since I don't use the remotes to open the doors and use the key to open the doors.The key starts the car every time so I would think that you have another problem with your starting circuit.
|
||
Top | |
Krytox |
|
|||
|
As above, the fobs are just for remote access.
Try smacking the panel at your left knee whilst turning the key. If the BEM has a fault, this is the way to test it! I'd be looking at the rear of the ignition barrel, common for them to come unstaked. also check all wiring.
_________________ Carefree, we may not be number one, but we're up there. |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 30 guests |