|
| mcflyin |
|
||
|
Guys,
Could really do with a bit of help. We got the computer installed and tuned at a place that we will never go to again. It took 3 weeks, cables left hanging everywhere. If the installation was messy we are worried about the tuning as well. Promised a hand controller but that is still a week away. We have a serial cable for the PC but don't know the pin arrangement into the Wolf. We know there is only a TX RX and GRD and it is into a 15 pin plug but don't know which pins to attach the three wires to. Can anyone tell us? Yours, Up the s**t Bonza |
||
| Top | |
||
| justfordima |
|
|||
|
Pin 1 - VCC (5 volts)
Pin 2 - Tx (OUT) Pin 3 - Rx (IN) Pin 5 - ground Pin 9 - 5 Volts Hope it helps. Cheers
_________________ ;++JustForDimSim++;
|
|||
| Top | |
|||
| mcflyin |
|
||
|
cheers mate, we got it runnin now
|
||
| Top | |
||
| justfordima |
|
|||
|
Good to hear!
Glad I could help. Cheers
_________________ ;++JustForDimSim++;
|
|||
| Top | |
|||
| CHEF |
|
|||
|
Was this dodgy installer on the sunny coast or brissy? Wolf dealer by any chance??
|
|||
| Top | |
|||
| mcflyin |
|
||
|
It was in Rocky
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 31 guests |
