|
| JACKOEF2 |
|
||
|
Just replaced the stock cam with a 1636 wade cam re set ecu but engine hunts how do you re set the idle its a ef2 4.0ltr
_________________ 2.5 CAT BACK , TICKFORD ENHACEMENT SUSPENSION, AND THE USUAL MODS |
||
| Top | |
||
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
The cam shouldnt play up with the idle that much. Mine runs fine except for the occasional lumpy 'miss' at idle.
|
||
| Top | |
||
| huggiebear |
|
|||
|
apparently you need to let the car idle for a while so the computer can learn the new settings. i think from memory it takes 15-30 minutes on idle to re-learn it all and run smooth. you should have noticed it run rough at first then smoothen out
|
|||
| Top | |
|||
| NUTZEF |
|
||
|
disconnect the battery for a couple of minutes then reconnect. chock your rear wheels start the car with the hand brake on as hard as it can go. now put the car in reverse and leave for 15 minutes. this should relearn the idle as it needs to be under load in gear. this can also be done if u have disconnected the battery on any car to relearn the idle
_________________ WOLF V500, t66(ar70 compressor), rochester 550cc injectors, borgg 265l fuel pump, 48mm turbosmart gate, turbosmart plumb back bov, 600x300x100 cooler, 3 inch zorst , 3.45 lsd, xr6 head, wade 1604 cam, adjustable cam gear, K&N pod filter, on 10psi and manual convertion exedy button clutch. 285.6rwkw |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 2 guests |
