|
| jonathon |
|
|||
|
96 xh Ute airbag HELP!!!
gday all i have just ran my diagnostic code reader through my brothers xh Ute and got a code and just need a little help with what its for 33 air bag - high resistance or open circuit? also the air bag light in the cluster flashers i have tried to pull the globe out but it sounds a alarm. just a little info on the car full exhaust, camed and chipped, t5, 250,000kms. any help is very much welcomed.. cheers all
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| jonathon |
|
|||
|
need help asap some one must know
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| tony.martin11 |
|
||
|
i know why, there is a sensor that 2 wires go into it behind the glovebox, the wires are covered by fluoro conduit. To replace it, easiest just to undo the top of the dash, look around for it (conduit runs to the far passengers side of the dash) and make sure the wires are connected. if not, the little f**k needs replacing (they are only like $5 max from the wreckers)
I found that out when i put my dash back in and forgot to connect it so the module beeped and the light flashed so i just lost 30mins and connected it back up with the dash just a little forward
_________________ BANNED USER |
||
| Top | |
||
| jonathon |
|
|||
|
would you have a photo of this.
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| tony.martin11 |
|
||
|
i can get a photo of where it is located for you, give me 10 minutes
_________________ BANNED USER |
||
| Top | |
||
| jonathon |
|
|||
|
cheers.
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| jonathon |
|
|||
|
cheers ashcook i have tried clearing the codes but it still flashers what do you mean by your BEMhad been out to upset it?
cheers
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| jonathon |
|
|||
|
could the BEM be at falt?
do they have a airbag modual?
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| jonathon |
|
|||
|
cheers might have a f**k around tomorrow.
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| jonathon |
|
|||
|
if i need to replace eather or both do they need to come from a xh ute?
cheers
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| jonathon |
|
|||
|
cheers
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| snap0964 |
|
|||
|
Find the blanking resistor (near the Airbag module, behind the fuse panel) pull it out and put it back in to it's plug.
The blanking resistor doesn't look the same as the EL PAB blanking one. Don't PM me - if I reply, it's via the applicable thread.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| jonathon |
|
|||
|
does any one have a phot of the blanking resistor?
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| snap0964 |
|
|||
|
ashcook wrote: Sorry snap For someone searching for the same info - You can't search PM's, but you can search threads. This is the reference sticky (use it !!!): ford-interior-f14/ef-el-airbag-system-ready-reference-t57569.html If you look at the ECU loom near the ECU, there are a couple of resistors/diodes which look similar to the XH blanking resistor taped to the loom a few inches from the ECU plug.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| jonathon |
|
|||
|
chers thanks for your help
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 67 guests |
