|
| opto |
|
|||
|
K&N
_________________ I post here cos the russian tank driver doesn't |
|||
| Top | |
|||
| EB91XR6 |
|
|||
|
I have the pod filter and it is easy to fit, jjust pull the air box off and put it on the end ot the tube suport it with a pod braket. i found that i get better fule ecconemy, a better note when in midrange and high range RPM's and did notice a small amount of power gain, well worth the money, get a POD
_________________ 1976 XC falcon
|
|||
| Top | |
|||
| Gaz |
|
||
|
or maybe not
_________________ 2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows |
||
| Top | |
||
| Aposta87 |
|
||
Age: 37 Posts: 337 Joined: 23rd Feb 2005 Ride: BA XTS, BF Xr6 Turbo Ute Location: Brisbane |
the general consensus here on fordmods seems to be K&N, personally I use K&N. 1000000km warranty, trusted brand and from what I have found and been told there has been alot of independent tests that prove they are better in the long run. but even if you say f**k all the tests . . there are alot of people here on fordmods that have them and never complain. I ahve never seen a post where someone complained about the efficiency or quality of their K&N.
_________________ Ford Fan: Since 1987 - Born a Blue Oval Supporter! |
||
| Top | |
||
| twr7cx |
|
|||
|
my falcon only drives on sealed roads, and tassie isnj't over populated like some of your eastern places
 so it's fairly clean and the K&n provides more than enough filtration for me!
|
|||
| Top | |
|||
| Jaylbreak |
|
|||
|
Back in my ford laser days the K&N air filter made a difference so it would make a bigger difference in a i6 or V8. The yanks invented these filters for drag racing so they must be better. Just listen to the difference in air suction when u rev your car
|
|||
| Top | |
|||
| South |
|
|||
|
This question is not about performance, or induction sound, or economy...
Its about the filter types and their efficiency to provide a much cleaner intake. Regardless of the cost involved with the filters... the concencus seems to be paper = better for engine longevity, foam = better for engine efficiency...
_________________ Fulli Sik Re |
|||
| Top | |
|||
| tomcolahan |
|
|||
|
South wrote: the concencus seems to be paper = better for engine longevity, foam = better for engine efficiency...
I'd agree with that. I'd also take into account the roads/conditions you are travelling. I wont use an oiled filter because of the amount of dirt roads I travel, paper for me.
_________________ We'll keep our cow s**t in the country, you keep your bull s**t in the city. |
|||
| Top | |
|||
| creeture3 |
|
||
|
Standard paper filters are the best. Just open the airbox and replace. No hassles about washing, drying, oiling etc., etc.,
They filter as good as any aftermarket filter |
||
| Top | |
||
| Ace |
|
||
|
twr7cx wrote: I went with K&N couse everyone else seemed too...
SHEEP!!! lol Nah K&N For sure, I put mine in after I put the snorkel on and I noticed a BIG difference in the responsiveness, therefore I swear by K&N, been one in every ford ive owned 
|
||
| Top | |
||
| Slick |
|
|||
|
South wrote: Im not concerned about the increase/decrease in flow and the resulting performance. My question is in regards to which do you trust to provide the cleanest possible intake your engine could ask for. uni-filter..................by far the best reusable filtration you can get!
flows 1% less then K&N but filters right down to 4-5 microns of dust particle compare to paper{30 microns} K&N{45 microns} anything above 15 microns will do damage 100% australian made. This question has been asked before, with the same reply.
_________________ Mind f**k!!! it works on feeble minded ignorant sheeples... there's plenty of em on this site... some are very intelligent but by god they are so thick!!! Pakrat wrote: You can buy them seppertly
|
|||
| Top | |
|||
| needfordspeed |
|
||
|
I just wanted a pod for the noise
I got a Simota, only $26.50.
_________________ 1988 EA S-Pack|MPI|LSD|AIT turbo manifold|Garrett GT3540|3" Exhaust turbo back|Resprayed|microtech LT8s|60lb Injectors|Bosch 044 with surge tank|3000 RPM stall|Ported AU head|Wade turbo cam|Crow double valve springs|1.3mm MLS headgasket|C4 conversion|Built bottom end|10.6@125MPHi |
||
| Top | |
||
| jules_1972 |
|
||
|
I used to think
"No way am I gonna pay $130 for a K&N". Well more fool me, best thing I ever did, actually replaced the standard filters in both cars with K&N's.... Geezus got an extra 2mpg out of the missus's BMW.... Bloody cheap and easy to clean, better filtration and better air flow. Win Win for all.
|
||
| Top | |
||
| jules_1972 |
|
||
|
I used to think
"No way am I gonna pay $130 for a K&N". Well more fool me, best thing I ever did, actually replaced the standard filters in both cars with K&N's.... Geezus got an extra 2mpg out of the missus's BMW.... Bloody cheap and easy to clean, better filtration and better air flow. Win Win for all.
|
||
| Top | |
||
| exholden |
|
||
|
paper filter. For mine, the K&N will give better performance, but I'm not convinced about it's long term effects.
There's plenty of time for the K&N users to find that it allows more air into the engine, filtering less dust. So why not cover your bases for the time being and use a paper filter? Err on the side of caution, if you get my drift? |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 144 guests |
