|
Au99forte |
|
||
|
Howdy I have a series one au that number 1 cylinder makes no change when removed. Replaced leads and has ok plugs. Even if it was a vacuum leak wouldn't it still make some difference when the leads takin off or does a leak stop the cylinder firing? Any ideas would be much appreciated,
Cheers Richard. |
||
Top | |
SWC |
|
||
|
Swap No6 with No1. Both fire at the same time with the AU. See what happens then.
Have you got spark on No1 & No6? If not the the coil pack has failed. Has No1 Injector failed? Does No1 Get fuel? |
||
Top | |
racer |
|
||
|
Common issue is coil packs. But i would do a compression test first. If that's ok then i would change coil pack with new plugs. It might have spark but it might be a weak spark.
_________________ FORD EL 4.0L. Crow cam, T.I Performance J3 Chip, Vernier cam gear, SPR ported head, 68mm TB, AU head gasket + ARP studs, AU injectors, Pacey 4480, High flow cat, Shift kit, Stallie, 3:73 TrueTrac. |
||
Top | |
Au99forte |
|
||
|
Yeah no 6 has spark and no1's spark seems as strong as others. There's fuel and I even swapped injector.. I have a new coil pack on the way just invade it's that
|
||
Top | |
Au99forte |
|
||
|
Have done compression test, changed coil pack still no luck. No 6 seems to be firing a lot harder than the rest
|
||
Top | |
Au99forte |
|
||
|
Have done compression test, changed coil pack still no luck. No 6 seems to be firing a lot harder than the rest
|
||
Top | |
Au99forte |
|
||
|
Have also swapped computer over
|
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 29 guests |