|
| Nathanhrv |
|
||
|
Hey guys, a mate just told me his 3 rear brake lights all went out, im guessing this is a blown fuse but he said the fuse looks in tact. Is there anything else that could cause the brake lights to fail (apart from blown bulbs) ?
Thanks guys |
||
| Top | |
||
| Johnson stroker |
|
|||
|
Check the brake switch on the actual brake pedal, these are known to fail as well.
_________________
|
|||
| Top | |
|||
| Nathanhrv |
|
||
|
thanks mate, and how do i check that? Sorry if thats a dumb question lol, but never checked it b4
|
||
| Top | |
||
| hans hartman |
|
||
|
Nathanhrv wrote: thanks mate, and how do i check that? Sorry if thats a dumb question lol, but never checked it b4 power in -switch-power out to lights-test light,press the pedal to complete the circuit,power both sides,if not-a new one.
_________________ R.I.P HANS HARTMAN |
||
| Top | |
||
| Nathanhrv |
|
||
|
Ok so ive diagnosed it that the brake switch is the problem however its not stuffed just loose. I had a fiddle with it while it was still connected and when i tilted it upwards the brake lights switched on, however when i put it back down the brakes went back off. i was gonna use a ziptie to hold it in the upright position however from the fiddling i think i blew the fuse as it stopped turning on when i tilted it up. i called it a day/night as i couldnt see sh*t haha so im gonna have another crack 2day
anyone got any ideas or tips? and also if my mate were to buy a new brake switch would this fix the looseness problem or is this an issue with where it mounts? Thanks guys |
||
| Top | |
||
| TROYMAN |
|
||
|
the brake light switch is stuffed, we had the same issue in our au, you could move it to get it to work then after a couple of times on and off the brakes it would stop again..
|
||
| Top | |
||
| Nathanhrv |
|
||
|
oh ok thanks troyman so getting a new one is the way to go?
Also any tips on removing and reinstalling? Thanks mate |
||
| Top | |
||
| elandau11extaxi |
|
||
|
get youre head under dash disconnect plug then pull out clip should be yellow watch out for plastic spacers they might drop pull out the pin then the switch should slide off to the left replace is the reversal hope this helps
|
||
| Top | |
||
| Nathanhrv |
|
||
|
hey guys all fixed now thanks for the tips, the switch was rooted and then i had to resolder one of the wires which became detached on the mount for the brake switch but all working now, thanks again
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 79 guests |
