|
4LEDboy |
|
|||||
|
Started to dissasemble the rocker gear from my AU motor and I noticed that the lifters in these motors don't have a dust cap and I cant figure out which part is the retainer. The top of them looks different to the lifters from an EL engine I have
They have a small clip arount the top of the lifter though, I guess this is the part I have to take off? Here a stupid looking diagram I made in paint, the clip I'm looking at is in the red box
_________________ Adelaide Motorplex < Click on it! You know you want too! Quote: Thats not the point *a**hole
|
|||||
Top | |
TROYMAN |
|
||
|
i think it would be best if you could take a pic??
to me it looks like the thing you have marked in your diagram is the retainer?? is it like a hard o ring?? but its really hard to say without a pic |
||
Top | |
4LEDboy |
|
|||
|
Yeah I'll get a pic, its hard to get the camera to focus in to show enough detail buy I'll have a go!
_________________ Adelaide Motorplex < Click on it! You know you want too! Quote: Thats not the point *a**hole
|
|||
Top | |
4LEDboy |
|
|||
|
Here is a picture, Its f**k blurry but it the best I can do!
EL Lifter on the left, AU on the right
_________________ Adelaide Motorplex < Click on it! You know you want too! Quote: Thats not the point *a**hole
|
|||
Top | |
TROYMAN |
|
||
|
they dont look that much different..
i think it was the retainer that you were refering to in the first post... |
||
Top | |
4LEDboy |
|
|||
|
Yeah its hard to see but the EL lifter has a slight chamfer before the groove where the retainer sits where as the AU one dosen't!
Cheers for the help!
_________________ Adelaide Motorplex < Click on it! You know you want too! Quote: Thats not the point *a**hole
|
|||
Top | |
4LEDboy |
|
|||
|
Ah well, done it!
Punched the lifter/shim out removed retainer inserted original shim and a new one Replaced HLA Taped it up! *Crosses fingers!*
_________________ Adelaide Motorplex < Click on it! You know you want too! Quote: Thats not the point *a**hole
|
|||
Top | |
Papa Smurf |
|
||
|
ED from the 01/04/1994 to the end of AU use the same lifter, they may have changed slightly the design or sourced from a different company but that's about it.
|
||
Top | |
elrob |
|
||
|
when i did my lifters in the au they never had the retainer on the new ones and didnt even think about removing from old ones,so there in there with no retainers and no problems
|
||
Top | |
4LEDboy |
|
|||
|
Cam is in, lets see what happens!
_________________ Adelaide Motorplex < Click on it! You know you want too! Quote: Thats not the point *a**hole
|
|||
Top | |
4LEDboy |
|
|||
|
Half way there!
_________________ Adelaide Motorplex < Click on it! You know you want too! Quote: Thats not the point *a**hole
|
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 101 guests |