|
| havok |
|
|||
|
Hey guys, I have an AUII XR6 and every now and then it struggles to start, usually when cold... I turn the key to ignition and it sits there coughin and splutterin while I have to hold the key in ignition for about 10 seconds before it starts. Usually have to pump the gas to get it to idle when it does this.
After it starts though it is fine, no lack of power or stalling or anything. I think it sounds like there is plenty of spark, so I am suspecting either fuel pump, filter, or possibly injectors (4 and 5 are ticking pretty severely)??? sure is annoying though especially when people look at your car in the car park struggling to start lol What do you guys think?... There is 2 filters isnt there, one at the back under the tank, and one next to the injection rail, is that right? Cheers, Brenton
_________________ EBII S XR6: 5 Speed short shifter, 4499s, gutted cat, 2.5" Redback, K&N Pod. |
|||
| Top | |
|||
| cp1pgo |
|
|||
|
if its only happening in the morning theres a possability of a almost dead battery
cheers.
_________________ 1995 EF Ford Falcon Fairmont |
|||
| Top | |
|||
| havok |
|
|||
|
Yeah it may be... But I am thinking fuel related as it seems to have plenty of spark... and starts to idle then it just stalls unless I hold the key in ignition for like 10 seconds. It probably does it once every 10-15 starts.
_________________ EBII S XR6: 5 Speed short shifter, 4499s, gutted cat, 2.5" Redback, K&N Pod. |
|||
| Top | |
|||
| Lukieman |
|
|||
|
Im currently looking into the same situation... I just sold my BA sedan for a BA ute... the sedan would start first time everytime at the turn of the key. With my ute, I have to engage the starter motor for about 5-6 seconds before it will even consider starting (hot or cold) and then usually blows a little white smoke??? Leaking gasket maybe?.
If anyone knows what might cause this let us know... Ive changed the plugs, air and fuel filters and blasted the throttle body with cleaner. And yeah, it is kinda embarassing cranking a newish vehicle for ages in the car park.
_________________ "...we can rebuild him, we have the technology... we just dont want to spend a lot of money." |
|||
| Top | |
|||
| sikwags_218 |
|
||
|
Hey how you doing? Is the AU using any water as of recent to me it almost sounds as if the head gasket it leaking into one of the bores. I would check the plugs for any rust like water has been getting in also watch for any white smoke exiting the exhaust on start up but then again could be a sticking injector, fuel pump not building up enough pressure etc etc
_________________ Falcon EB 1 wagon, ported/polished/cc'd head. K-line valve guide. 3-angle valve grind. Extractors. Hi-flow cat. 2 1/2 mandrel bend exhaust. re-built motor with ACL parts. Roll Master timing Kit. Manual conversion. Lowered 3in. Full Spooled Diff. Broad Band Manifold conversion. Stage 3 Crow Cam. |
||
| Top | |
||
| havok |
|
|||
|
It does lose water out the overflow tank I think there may be air in the system. The oil appears normal so I don't think it is a head gasket. I may be wrong though.
_________________ EBII S XR6: 5 Speed short shifter, 4499s, gutted cat, 2.5" Redback, K&N Pod. |
|||
| Top | |
|||
| xcbest |
|
||
|
it is head gasket--water gallery to cylinder leak----before starting for first time in morning remove all plugs---open full throttle---crank engine on starter---watch plug holes---bet you see water or water vapor blowing out of 1 or more holes--
|
||
| Top | |
||
| havok |
|
|||
|
xcbest wrote: it is head gasket--water gallery to cylinder leak----before starting for first time in morning remove all plugs---open full throttle---crank engine on starter---watch plug holes---bet you see water or water vapor blowing out of 1 or more holes-- I'll try this at some stage, this would definitely indicate a blown head gasket? Is it normal to not lose any power if you have a blown head gasket? cheers for the replies
_________________ EBII S XR6: 5 Speed short shifter, 4499s, gutted cat, 2.5" Redback, K&N Pod. |
|||
| Top | |
|||
| phillyc |
|
||
|
havok wrote: xcbest wrote: it is head gasket--water gallery to cylinder leak----before starting for first time in morning remove all plugs---open full throttle---crank engine on starter---watch plug holes---bet you see water or water vapor blowing out of 1 or more holes-- I'll try this at some stage, this would definitely indicate a blown head gasket? Is it normal to not lose any power if you have a blown head gasket? cheers for the replies |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 101 guests |
