|
| MrMitch |
|
||
|
Hey guys I got some extractors and a hi flow cat off a friend of mine but it's off an au xr6 tickford, would it be a straight swap for my stock manifold and cat, I know the cat bolts up the pipe replacing the old but looks like I would need to take off the steering (column)? In the engine bay to get enough room to drop the bottom end of the extractors in
|
||
| Top | |
||
| SWC |
|
||
|
Straight bolt up.
Why would you need to remove the intermediate shaft? Are you trying to fit it with the cat attached? |
||
| Top | |
||
| MrMitch |
|
||
|
Unless I'm doing something wrong with trying to fit it around the shaft I thought the bottom end of the extractors were too big to fit through the gap and no I'm fitting it without the cat attached
|
||
| Top | |
||
| SWC |
|
||
|
Should fit through the gap. Can be a little tight and you will need to twist the extarctors around a bit.
You can pull the intermediate shaft if you want, just don't move the steering wheel with it removed. |
||
| Top | |
||
| MrMitch |
|
||
|
*update*
Extractors are now in but the bloody flange on the cat that bolts up to the extractors is angled wrong so it's booked in at a local exhaust shop to get reangled tomorrow morning! Fingers crossed this is my last hurdle 
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 54 guests |