|
| jamie22_cole |
|
|||
|
hey just wondering what is causing my rebuilt EL XR6 engine to still burn oil after 40,000 after rebuild. if i put 5.5lt of oil after a oil change then when the next oil change is due, should there be the same amount of oil in there when u first put the oil in or will there be less?
|
|||
| Top | |
|||
| 93EB |
|
|||
Age: 47 Posts: 2485 Joined: 6th Oct 2005 Ride: 93EB Fairmont / BA Falcon XR6T Location: Western Sydney |
Its normal for all cars to use a tad of oil between services but if it is excessive get it looked into.
_________________ 93 EB II Fairmon8 with 17' EL GT's / Clear indicators / H.I.Ds / Sports exhaust / Lowered 2' / K&N / XR6 ECU. |
|||
| Top | |
|||
| krisisdog |
|
|||
|
How much is it using?
|
|||
| Top | |
|||
| TIAMO |
|
|||
|
Check wether it is burning or leaking oil. After a 'proper' rebuild you should lose almost no oil. Keep in mind a 500-100km oil change if there's been any machining erc to remove metal particles.
|
|||
| Top | |
|||
| jamie22_cole |
|
|||
|
well its been 40,000kms so far and its still burning oil. i check it today and it was below the okay mark and i service it every 5,000kms.
|
|||
| Top | |
|||
| sd1800 |
|
||
|
You positive it's not leaking?
Our EB2 is losing about 1.5litres every 2000km / 3months but when you have a look under the car you can see where its going....undercarrige is covered in the stuff lol.
_________________ Formerly LV XR5 Turbo, AU Fairmont Ghia V8 & EBII Fairmont I6. |
||
| Top | |
||
| jamie22_cole |
|
|||
|
nope no leaks at all.
|
|||
| Top | |
|||
| frd906n |
|
||
|
did u replace, rear main seal on the back off the engine, behind the fly wheel
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
| Top | |
||
| TROYMAN |
|
||
|
jamie22_cole wrote: nope no leaks at all. to that i would say that it may not have been run in properly.. |
||
| Top | |
||
| Johnson stroker |
|
|||
|
TROYMAN wrote: jamie22_cole wrote: nope no leaks at all. to that i would say that it may not have been run in properly.. this would be my suggestion to, what sort of tollerances did you observe when you built it? I built mine, its pretty tight on tollerance, but I6 motors love that.
_________________
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 115 guests |
