|
| RustyEF |
|
||
|
im not sure what cam to go for, i hear CROW CAM are good, and WADE CAM.
plus others, i dont want to change computer as of yet. here are some. WADE CAM 1004 whats the diffence between 1004 and 1004 -14 WADE CAM 1604 WADE CAM 1636 CROW CAM STAGE 2 Sure Cams OXY35 MM DEV3HL cam and what would the prices be for each cam.?and what wouldmy best bet be. i just want more midrage power, and hopfully Economy. thankz kyle
_________________ -------EL Fairmont Ghia with CUstome BA XR body kit------- |
||
| Top | |
||
| voxace |
|
|||
|
I'be got a 1004. They are ground on a 112 LSA, whereas the 1004-14 has a 114LSA. All this means is a slightly better idle, and a little less power.
All the cams listed should be fine on the stock computer. The wade cams will set you back about $200-$250 all up including postage, shims, lifter repair kit etc. The crow I think will be around $400. The JMM will set you back around $750 at least. Another option is ALTED cams, around $300 I think, or CMS cams (not sure about the price). For midrange power, good idle and economy I think the ALTED cam would be the go. |
|||
| Top | |
|||
| ReGiE |
|
|||
|
the CMS cams were around the 500 mark with a vernier cam gear
_________________ Gooooone - Eb2 Coon - 143RWKW |
|||
| Top | |
|||
| Slabz |
|
|||
|
voxace wrote: I'be got a 1004. They are ground on a 112 LSA, whereas the 1004-14 has a 114LSA. All this means is a slightly better idle, and a little less power.
All the cams listed should be fine on the stock computer. The wade cams will set you back about $200-$250 all up including postage, shims, lifter repair kit etc. The crow I think will be around $400. The JMM will set you back around $750 at least. Another option is ALTED cams, around $300 I think, or CMS cams (not sure about the price). For midrange power, good idle and economy I think the ALTED cam would be the go. the wade cams seem really cheap...are they any good?
_________________ EBII 4.0L GLi | T5 | 3.27 Spool | POD | KKK K27 Turbo | 600x300x76 FMIC | 40mm Wastegate (dead) | RPD Stg1 Cam | B&M Launch Control | Thermos | 3" Dump | Twin 2.25" Zorst | 197kw@3500rpm, 7psi LEAN!
|
|||
| Top | |
|||
| voxace |
|
|||
|
Yeah their alright, the ones listed are pretty mild. They are regrinds done by a camshaft company.
If you look at the other places, JMM & ALTED for example.... they are Inline 6 specialists. |
|||
| Top | |
|||
| drazull |
|
||
|
I would presume you have a set of extractors and a sports exhaust?
Then the cam. I would go chip first before cam. Why? Because A monster cam needs a chip.
_________________ Not lost any demerit points |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 58 guests |
