|
| toddy69 |
|
||
|
hi guys, ive been reading up on all the different cams. but i still hav a couple of questions for you guys, i want to change my cam for ofcourse more power, but also want to get a good sounding idle from my car. i was just wondering if u guys could tell me what i would need to get done to get a new cam with a good idle also, and also could some1 recomend a place to in s.a to get cam work/ headwork done?
|
||
| Top | |
||
| toddy69 |
|
||
|
any1?
|
||
| Top | |
||
| GeZza200 |
|
||
|
Wade 1636 or 1673 would be the way to go, good power increase and good idle.
_________________ EL Futura: CVE head, Wolf V500, ICE Ignition and Coil, 36lb injectors, Walbro 255lb, Paci comps, 3" exhaust, T5, Harrop Truetrac with 3.9s. Now with 198.9rwkw, (~185rwkw and 13.80 @99.1mph) with more power to come |
||
| Top | |
||
| toddy69 |
|
||
|
will they need anything to run either of them? headwork, tune, that sorta thing? also does any1 no sumwhere in sa to get that sorta work done?
|
||
| Top | |
||
| slammeb |
|
||
|
toddy69 wrote: will they need anything to run either of them? headwork, tune, that sorta thing? also does any1 no sumwhere in sa to get that sorta work done? Email wade and sort it out. Send yours off and the'll regrind it for 150ish or give them and extra 150 deposit until you send yours back. No chip or headwork needed. 977B will sound a bit lumpy without a tune. |
||
| Top | |
||
| toddy69 |
|
||
|
okk cheers,, but does any1 know anywhere in s.a to get a cam swaped over, or to get sum sort of head work done?
|
||
| Top | |
||
| slammeb |
|
||
|
toddy69 wrote: okk cheers,, but does any1 know anywhere in s.a to get a cam swaped over, or to get sum sort of head work done? If your not going to chip it why bother with headwork? Do a search, the only way you'll get a cam is buy getting one reground by sending it off. |
||
| Top | |
||
| SWC |
|
||
|
Not in SA but check this thread, crescent-motorsport-f48/cms-stage-2-e-series-head-cam-package-t55396.html
|
||
| Top | |
||
| toddy69 |
|
||
|
SWC wrote: Not in SA but check this thread, crescent-motorsport-f48/cms-stage-2-e-series-head-cam-package-t55396.html cheers for that man, i had a look at it. but would it be worth getting sumthing like that n then putting a wade cam in it or is the cam that comes with it good enough. also does any1 know where to get this kinda work done in sa, or where i could take my car to get the new head installed? |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 70 guests |