|
| duvauchellemotors |
|
|||
|
Is thier any differences in the two?
Will a I6 t5 go fine on a EB v8? |
|||
| Top | |
|||
| Krytox |
|
|||
|
nup
i6 has a shorter input shaft. otherwise, same box.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| SpeedyED |
|
|||
|
Is it possible to swap the input shafts over?
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| XFWAGON |
|
|||
|
Technically you can swap the inputs over, i have seen them cheap on USA eBay, but in saying that i think the Mustang 302 input shafts are a different length than the Aussie ones. Just get a bell housing from CRS, then you can bolt up an i6 T5. Just don't get an AU T5 like i did!!
|
|||
| Top | |
|||
| MRE-50L |
|
|||
|
ok
there a 16mm difference in the input shaft length , v8 shaft is longer . an No you can not swap the input shafts over as the gears are a different diameter , i have tryed it with a 5L shaft into a 6cly box and it didnt fit , but you can get your 6cyl shaft lengthened to the right length for the V8 aplication
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| cjh |
|
|||
|
{USERNAME} wrote: ok there a 16mm difference in the input shaft length , v8 shaft is longer . an No you can not swap the input shafts over as the gears are a different diameter , i have tryed it with a 5L shaft into a 6cly box and it didnt fit , but you can get your 6cyl shaft lengthened to the right length for the V8 aplication What was longer???, the spigot, or the spline, or both????
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 31 guests |
