|
| Mark westy |
|
||
|
Hi all my mates putting a ea intake on his ef motor so when he turbos it, it Is less cooler piping. But for now he need to know where the 3 vacuum lines on that 3 vacuum tree go and the two fittings of the manifold itself go if you could let me know or post a picture of them it would be much appreciated.
Cheers |
||
| Top | |
||
| evxr6 |
|
|||
|
Brake booster, fuel regulator, HVAC controls.
There is a picture on page 13 or 14 of my thread.
_________________ Current ride: MY03 Liberty RX Wagon |
|||
| Top | |
|||
| Mark westy |
|
||
|
Cheers mate, I went from about page 10-20 on your thread couldn't find it I don't think but I know the big line in the vacuum tree goes to the brake booster but not sure about the other 2 and I know the big line in the manifold itself goes to the breather on top of the motor but also not sure where the little one goes that's on the manifold itself
|
||
| Top | |
||
| evxr6 |
|
|||
|
The other manifold line goes to the purge solenoid tree for the evaporative control system.
The other two off the back are as above. There's a few pictures with the engine out. That's the best I have.
_________________ Current ride: MY03 Liberty RX Wagon |
|||
| Top | |
|||
| Mark westy |
|
||
|
Alright mate thanks for your help think I know have a pretty good idea where they go
|
||
| Top | |
||
| TROYMAN |
|
||
|
the small ones on the vacuum tree should be map sensor, fuel reg and heater controls.
|
||
| Top | |
||
| evxr6 |
|
|||
|
Troyman wrote: the small ones on the vacuum tree should be map sensor, fuel reg and heater controls. I knew I forgot one.
_________________ Current ride: MY03 Liberty RX Wagon |
|||
| Top | |
|||
| Mad2 |
|
|||
|
Troyman wrote: the small ones on the vacuum tree should be map sensor, fuel reg and heater controls. i'd best make a 'note' of that ...... 
|
|||
| Top | |
|||
| EF_wanabe |
|
||
|
Mad2 wrote: Troyman wrote: the small ones on the vacuum tree should be map sensor, fuel reg and heater controls. i'd best make a 'note' of that ...... I am baffled i never knew the map sensor connected via that T piece , looks like alot easier to replace the line now |
||
| Top | |
||
| Mark westy |
|
||
|
Ok so I've found where they all go exept 1 and it goes to something not really sure on what it is, I searched the part number and found it was call (Thermactor Air Control Solenoid Vacuum) not sure how right that is though but two line come of the mani to it and I only got one more line to run of the mani do I have to plug them into it, it is found on the firewall on an ef on the passengers side.
Cheers |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 33 guests |
