|
salemboicot |
|
||
|
I have a te cortina and have scored an ea falcon motor to put into it.
How hard would it be to hook the computer up?? Cos as far as I can tell the engine should fit. The problem is that I'm going from a 2ltr to a 6cyl and want to know the hassle of getting engine mounts, could I use 6cyl cortina mounts without any major mods? I also have no gear box to fit engine as the trans from the falon pooed itself. I was told a xy falcon box should bolt up without too much work to the corty. Any ideas, or suggestions? thanks
_________________ I'd rather push the corty than drive a Jappa!! |
||
Top | |
FPV_GTp |
|
||
|
salemboicot wrote: I have a te cortina and have scored an ea falcon motor to put into it.
How hard would it be to hook the computer up?? Cos as far as I can tell the engine should fit. The problem is that I'm going from a 2ltr to a 6cyl and want to know the hassle of getting engine mounts, could I use 6cyl cortina mounts without any major mods? I also have no gear box to fit engine as the trans from the falon pooed itself. I was told a xy falcon box should bolt up without too much work to the corty. Any ideas, or suggestions? thanks the mounts on the engine will be the same as the x-series falcon so just a set of mounts out of a 6cylinder cortina will do the trick to mount the engine in the engine bay the wiring is not hard to do , simple just take ur time , is ur motor a CPI or a MPI efi setup ? The EA motor has different bellhouse pattern to the x-series falcosn so dont know who told u a xy one will fit straight on , its not the case from the few cortinas that i have modified for guys through the years the four cylinder rear gear box mount is in a different spot and needs to be reloctaed if ur sya transplanting a 6 cylinder crossflow and 4spd single rail into a 4 cylinder version of the cortina. say that i suspect it will be the same case putting in the E-sereis motor and gearbox in there whats involved in the rear gearbox mount is , undoing the spot welds that the mounting brackets that are spot welded to ur floor pan and reloctaeing it further back torwards the diff , u will have to have a bellhousing and gearbox to dumby things up , again a bit of work but not hard to do cheers have fun
_________________ WANTED - Complete BTr4 and zf 6hp26 automatic transmission 6 cylinder and V8 transmission(s) suit rebuild? Drop me a PM if you can help would be greatly appreciated - thanks |
||
Top | |
mrnasty |
|
|||
|
why dont you try to find yourself an EF/EL motor, and wiring loom/ecu, pretty similar to EA motor, same block n all. Then you have the broadband manifold, 157kw to start off with.
cam, extractors, decent pipe, maybe some headwork and a cai the corty will fly!
_________________ Cougar Zero makes my pants fit nice. |
|||
Top | |
salemboicot |
|
||
|
sounds like a fairly easy little project. Cheers for the help, I just wasn't 100 percent sure. I might scrap the ea motor and get one with a box so that I don't have to hunt one down.
Keep an eye out for a lime green corty around brisbane.... that has 2ltr badges and goes surprisingly well for a 4 cyclinder!!
_________________ I'd rather push the corty than drive a Jappa!! |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 35 guests |