Fordmods Logo

ED hasn't been started in forever - is it dead? 

 

Page 2 of 2 [ 29 posts ] Go to page Previous  1, 2

 
Posted: Thu Apr 26, 2007 1:47 am 
Technical Contributor
Offline
User avatar

Age: 60

Posts: 5659

Joined: 14th Jan 2005

Gallery: 10 images

Ride: 96 XH/97 EL

Location: South Coast
NSW, Australia

The question was simply what to do beforehand, and if engine may be seized.
Here's what i'd do:

Fuel system: Drain fuel by earthing top right pin diagnosis connector, turn ign on (pump runs continuously), remove fuel filter, use this point to drain.
Remove fuel pump, inspect tank inside - tank may need to removed as you may find a fungus or 'barnacle' type buildup inside. Clean tank if necessary. Renew fuel filter, clean pump pickup if necessary. Pump might be marginal.
Injectors may need cleaning, due to gumming up - this will be determined when running.

Cooling system: check for coolant level and condition - use test strips to check coolant health.

Oil system: Lube top cylinders through spark plug holes. Lube rocker gear and camshaft. Check oil level and condition, if okay, engine can be run, but oil and filter change is recommended soonish.
Motor engine over (CRT LP fuse pulled to disable starting) until oil light goes out, or oil pressure is up to normal range. DO NOT run the engine without building oil pressure first.
Lifters may be noisy for a while.
Run the engine for a good half to three quarters of an hour.

 

_________________

96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl
97 EL Futura S/W: LPG, Alarm, LED int Lts, Trip Comp, F/Lane Dome Lt, Climate Ctrl, T5 Conversion

Top
 Profile  
 
 
Posted: Thu Apr 26, 2007 10:57 am 
Getting Side Ways
Offline
User avatar

Age: 38

Posts: 4323

Joined: 17th Jan 2006

Ride: Soarer 2.5GT-T

Location: Cranbourne
VIC, Australia

thanks very much snap, that's exactly the sort of answer i was looking for.
by "lube cylinders through spark plug holes" do you mean just pour some oil down there? if so how much? And what sort of oil should I use? 20/50? Thanks a lot.
Top
 Profile  
 
 
Posted: Thu Apr 26, 2007 8:00 pm 
Technical Contributor
Offline
User avatar

Age: 60

Posts: 5659

Joined: 14th Jan 2005

Gallery: 10 images

Ride: 96 XH/97 EL

Location: South Coast
NSW, Australia

NP.
Any motor oil will do - just a light squirt into each cylinder case, just to aid initial lubrication, as you will find the bores will most likely have some surface rust.

 

_________________

96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl
97 EL Futura S/W: LPG, Alarm, LED int Lts, Trip Comp, F/Lane Dome Lt, Climate Ctrl, T5 Conversion

Top
 Profile  
 
 
Posted: Sat Apr 28, 2007 11:50 pm 
Getting Side Ways
Offline
User avatar

Posts: 1863

Joined: 30th Apr 2006

Location: Melbourne
VIC, Australia

It'd surprise you what will start with a bit of effort. A few years back we had a late 50's Mercedes that hadn't been started in15-20 years. My uncle was giving it to me, so we thought we'd try to get the bugger going. With a bit of fuel, topped up the oil and a new battery it started within 10 seconds!
Top
 Profile  
 
 
Posted: Sat Apr 28, 2007 11:54 pm 
Getting Side Ways
Offline
User avatar

Posts: 3331

Joined: 27th Dec 2004

Gallery: 4 images

Ride: MCMXCV Falcon

Location: G town
VIC, Australia

Private9 wrote:
It'd surprise you what will start with a bit of effort. A few years back we had a late 50's Mercedes that hadn't been started in15-20 years. My uncle was giving it to me, so we thought we'd try to get the bugger going. With a bit of fuel, topped up the oil and a new battery it started within 10 seconds!


ohh but this is a precious EB falcon, you cant just start it!!

 

_________________

Image

Top
 Profile  
 
 
Posted: Sun Apr 29, 2007 9:49 am 
Getting Side Ways
Offline
User avatar

Age: 56

Posts: 1967

Joined: 13th Aug 2005

Ride: 2000 Au wagon

Location: some where in nsw
NSW, Australia

Quote:

oh but this is a precious EB falcon, you cant just start it!!


and don't you forget it .

so have you started it yet.

 

_________________

Image

Top
 Profile  
 
 
Posted: Sun Apr 29, 2007 10:35 am 
Technical Contributor
Offline
User avatar

Age: 45

Posts: 4093

Joined: 20th Mar 2005

Gallery: 2 images

Ride: 2.0 Turbo VW

Power: 142 rwkw

Location: Seaford State:
VIC, Australia

When you get it going, make sure you give it a good birthday.

ohh thats after blowing out the cob webs!

If your keeping it, I'd advise you to replace the waterpump at the very least.

 

_________________

Carefree, we may not be number one, but we're up there.

Top
 Profile  
 
 
Posted: Mon Apr 30, 2007 11:54 pm 
Getting Side Ways
Offline
User avatar

Age: 41

Posts: 1160

Joined: 25th Apr 2005

Gallery: 11 images

Location: Melbourne
VIC, Australia

started it yet ?
Top
 Profile  
 
 
Posted: Tue May 01, 2007 1:39 am 
Getting Side Ways
Offline
User avatar

Age: 39

Posts: 4401

Joined: 25th Mar 2005

Ride: BA XT, BA XR6T, ED Ghia 5.0

Location: Perth
WA, Australia

do a burnout, that'll get her going!

 

_________________

What's the difference between a Holden and a sheep? It's less embarrasing getting out of the back of a sheep..

Top
 Profile  
 
 
Posted: Tue May 01, 2007 2:42 am 
Getting Side Ways
Offline
User avatar

Age: 35

Posts: 511

Joined: 6th Feb 2006

Gallery: 3 images

Ride: BA Falcon Classic

Location: Perth
WA, Australia

fnp wrote:
do a burnout, that'll get her going!


he's gotta start it first!

 

_________________

When you do things right, people won't be sure you've done anything at all.

Top
 Profile  
 
 
Posted: Tue May 01, 2007 2:49 am 
Fordmods Junkie
Offline
User avatar

Posts: 11752

Joined: 17th May 2005

Gallery: 11 images

Ride: EL Fairmont, VFR400 racer

Power: 144 rwkw

Location: Melbourne
VIC, Australia

shannonwulff wrote:
fnp wrote:
do a burnout, that'll get her going!


he's gotta start it first!


I believe shannonwulff is correct on that one fnp :P

did you get it started douche?

phong =P~

 

_________________

phongus = Post whore 2006
EL XR6 motor, EL ECU + J3 chip, WADE 1673 Camshaft, 3" S/S intake, Pacy 4480, 2.5" Hi flow cat, 2.5" Lukey exhaust.
Max Power = 144.6 rwkw (03/05/2008)

Top
 Profile  
 
 
Posted: Wed May 02, 2007 11:08 am 
Getting Side Ways
Offline
User avatar

Age: 38

Posts: 4323

Joined: 17th Jan 2006

Ride: Soarer 2.5GT-T

Location: Cranbourne
VIC, Australia

haven't had five seconds alone with the car! it's coming though!!! lol
Top
 Profile  
 
 
Posted: Sat May 05, 2007 1:11 am 
Stock as a Rock
Offline

Age: 36

Posts: 181

Joined: 3rd May 2007

Location: pinjarra
WA, Australia

lol harded princess top the oil up put some feul in it wind it over for a few sec (coil leed off) then start the thing .... it was built ford tough remember
Top
 Profile  
 
 
Posted: Sat May 05, 2007 1:48 am 
Oompa Loompa
Offline

Age: 42

Posts: 43

Joined: 1st Jan 2005

Ride: BA Fairmont

Location: Riverland
SA, Australia

c'mon, crank it.

If i can get an old renault 12 to kick over and go after over 10years sitting in the elements with only a new battery and sparkers, sureley this baby will go.

Biggest problem i had with the old renault was the brake pads had rusted to the rotors, fwd reverse, forward reverse etc for a bit and she moved
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 2 of 2  [ 29 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 87 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Wed Nov 27, 2024 6:33 pm All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names