hi all just bought a edxr8 for my sis and we have just finished an ef dash conversion, everything worked fine untill i tried to wire the tacho up to the pink/green wire off the coil (this was to stop the needle from jumping around) i have done this on my edxr6 before and got good results tacho was steady and no problems afterwards.
The xr8 now starts but only runs for a few seconds and then cuts out... I took the tapped wire back off and still no go, i thought it was a fuel problem as the tank was running quite low but ive put in a new pump and filter and again still not working... Ive checked all the fuses i could find swapped all the relays and returned eveything back to to the way it was before the problem began,

any help would be greatly appreciated

cheers jesse

problem solved, feeling pretty stupid too, didnt notice the cannister on the air intake had cracked off so all sorted