|
| Krytox |
|
|||
|
I have an EF and its about due for a clutch replacement!
Its just started to be a b**ch getting back into 1st and can feel it hesitating to get into second, with double clutching the problem is solved for me... However I don't want the other half whom drives the car to damaging my T5. Anyways.. The fork seems straight so at 130K's i thought the pressure plates about cactus! So any suggestions on brands? I was keen on getting a PBR XR6 Equiv. I don't want a hard clutch and I don't want to pull the firewall towards my foot either! so.. Advice of brands would be muchly appreciated! eg, Pros/Cons Cheers
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| altedxr6 |
|
|||
|
I run RPM clutches in my cars, Not a problem with them ...
But its always a good idea to get the firewall welded up for strengh . |
|||
| Top | |
|||
| The_Jackal |
|
|||
|
where would be the best place to strenghten the firewall? is it around the hole for the clutch cable?
_________________ EF XR8 - 5speed, Extractors & Exhaust |
|||
| Top | |
|||
| falconea |
|
||
|
Have u checked the clutch adjustment. If the clutch is draging then u will have trouble getting into gear. Maybe the cable is on the way out or stretched. Check this as it may save u money. U did not say if the clutch was slipping at all.
_________________ Drive safe, arrive alive
|
||
| Top | |
||
| bogan393 |
|
|||
|
How much power are u planning to run? Ive heard good things about the rpm clutches for midly worked cars. I sourced alot of info for my ea when i was planing to turbo it and the best combination i was recomended was a geniii pressure plate witha custom clutch plate, it was gonna cost $1100 unfitted and firewall strengthening was required.
_________________ Rides:
|
|||
| Top | |
|||
| Krytox |
|
|||
|
The Clutch is not slipping at all.
I have tried other cables (same result) The Clutch thrust bearing + fork seems (not physically bent). I can only narrow this down to the Clutch fingers being tired, the further I push the thrust bearing and after a basic drive it returns to the same old. for a few hundred bux i'll just replace it and reface the flywheel, just need a good idea on what to get, RPM seems good I had one of those in my 5ltr holden ute, But i don't need a pretty yellow clutch in a family car :) and for the record, I have 142.5rwkw and now is a daily driver.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| Smackdown |
|
|||
|
The_Jackal wrote: where would be the best place to strenghten the firewall? is it around the hole for the clutch cable?
Yes... I just welded mine back up, if it goes again some 6mm steel plate will be going in its place. RPM clutches are wikid, I run one and I can't complain.
_________________ BA Falcon Futura on EGas. Stock as...
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 99 guests |
