|
| robo_1988 |
|
||
|
hey just wanting to no if I was to put ef engine loom and dash loom in my eb would the ef engine be able to run off coil pack set up and is there any rewiring that needs to be done for the dash conversion I tried searching but couldn't really find anything on it thanks
|
||
| Top | |
||
| SWC |
|
||
|
You would need the full engine loom, dash loom as you have said as well as EF ECU and BCM. Snap may be better qualified to anwser the question but as long as you do the full wiring I can't see why not.
Why do you want to fit the EF loom and run Coilpack? Much easier just to put you EB Accessories and dizzy etc onto the EF Motor and you are away. |
||
| Top | |
||
| robo_1988 |
|
||
|
the only reason I wanted to use the ef loom and ef coil pack is because I have a complete ef that I am taking the manual conversion out of for the eb and wanted to do engine swap as well
|
||
| Top | |
||
| SWC |
|
||
|
Just swap over the loom from your EB and intake manifold, or you could leave the BBM and add a RPM switch, Leave the serpentine set up, use the EF accesories and fit the EF Radiator. Do the resistor trick for the Auto EB ECU or get your self an EB/ED/EL Manual ECU and you are away.
|
||
| Top | |
||
| robo_1988 |
|
||
|
ok thanks for that
|
||
| Top | |
||
| SWC |
|
||
|
There is a little more to it than what I said but it is still pretty simple. here is a link to Troymans AU engine install to his ED. Have a read of that and just ansk about what you are not sure of.
documents.php?d=85 |
||
| Top | |
||
| Gab1 |
|
|||
|
I'd just retain all the EB accesories, dissy and the whole lot, and bolt the manual box behind it, and eithier source a manual EB ECU or do the resistor trick.
Gab |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 91 guests |
