|
| MooseMan |
|
|||
|
Since I put the manual in my car if I need to brake a little hard or put the clutch in a hurry then the car just loses power and cuts out. I have to put it in gear and let go of the clutch and it fires up again but I have no idea why its doing this.
_________________
|
|||
| Top | |
|||
| phongus |
|
|||
|
Your ISC might need attention or ECU needs to relearn the idle speeds. There is a topic somewhere about doing a set procedure to allow the computer to idle better?
hope that kind of helps phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| rushed |
|
|||
|
so it stalls when your stopping? or say down shifting from 4th to 3rd @ 60kph??
i assume youve checked the isc on your car, mine needed MAJOR adjustment after my manual conversion. another q... are you using a tricked auto ecu/or manual one |
|||
| Top | |
|||
| jeffb |
|
|||
|
Mine was doing this after I did a conversion, if you pushed the clutch in with it at 2000rpm or something it would just stop, but if you left the clutch out till you were nearly stopped it would be fine.
I found my problem to be spark related more than anything, gave the dizzy cap a clean, new sparkys, helped a lot, check your ISC tho it could have something to do with it as well. |
|||
| Top | |
|||
| MooseMan |
|
|||
|
Yeh im using the auto ECU. I have no idea what the ISC is? The car stalls at random speeds like going from 4th to 3rd at 60.
_________________
|
|||
| Top | |
|||
| jeffb |
|
|||
|
Idle Speed Controller, little cylander looking thing bolted to side of the throttle body, did you leave your neutral switch plugged into the loom and in N? also the resistor trick for gearbox temp etc?
|
|||
| Top | |
|||
| MooseMan |
|
|||
|
I did the resistor trick of soldering two of the wires together with resistors in between and soldering two others together.
_________________
|
|||
| Top | |
|||
| eb_guy888 |
|
||
|
just throwing the idea out there... u can drive a manual cant u?
 Not just stalling on u lol
sorry man had 2 ask, trust me theres been some sillier questions asked and found out there right lol |
||
| Top | |
||
| kizzer |
|
|||
|
hey mate.
mine was doing this aswell. did it for about 3weeks then it just stopped and never happend again untill i swithced to a manual ticky 1 then it started again then stopped about 2weeks later.
_________________ 1995 EF Fairmont with all the Gear. |
|||
| Top | |
|||
| rushed |
|
|||
|
try reset the computer?
if that fails check the isc, ontop of the throttle body, there should be guide on how to adjust idle speed around here somewhere. |
|||
| Top | |
|||
| twase |
|
|||
|
I think this may be normal as you had the battery disconneccted and the ECu neds to relearn.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| twase |
|
|||
|
BTW mine did this as well.
_________________ BF Fairmont Ghia Series II update. Last edited by twase on Mon Mar 12, 2007 7:12 pm, edited 1 time in total. |
|||
| Top | |
|||
| MooseMan |
|
|||
|
Yeh ill see if it gets any better. Although I did 800kms yesterday and it didnt help. I can drive fairly well and my brother and dad(both mechanics) who are great drivers have had it happen to them aswell.
_________________
|
|||
| Top | |
|||
| Mitch_ |
|
|||
Posts: 6168 Joined: 5th Nov 2004 |
mine took about 2 weeks to calm down, and still does if i disconnect the battery
_________________
|
|||
| Top | |
|||
| kizzer |
|
|||
|
i just went and change my ecu back to my old 1 and its doing it again so im pretty sure its got something to do with learning ey.
_________________ 1995 EF Fairmont with all the Gear. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 33 guests |
