|
| winman |
|
|||
|
ba xr6 na, xforce 2.5' mild steel exhaust
ive had this annoying rattle in my exhaust for a little while now, pretty much its from low in the revs. ive found the issue, its the exhaust pipe rubbing/hitting the heat shielding,area of contact is in between the two mufflers where the exhaust runs up over the rear axle. ive tried bending the heat shield back but it didn't do much good. can any one see any issues i might have with wrapping that section of the exhaust in exhaust tape, then cutting out the heat shield that's making contact?
_________________ BA XR6 |
|||
| Top | |
|||
| Gab1 |
|
|||
|
Put some big hose clamps around it. Other than that I cant really see too many issues doing what you said.
Gab |
|||
| Top | |
|||
| hans hartman |
|
||
|
wrap the pipe after you lower it,dont cut the heat shield.wrap 40 -50mm each side of the rubbing bit,can loower the pipe 3mm as well
_________________ R.I.P HANS HARTMAN |
||
| Top | |
||
| muzza |
|
|||
|
Get some silicone.... must be the roofing stuff (not the coloured bathroom version).
Squirt the silicone in between the heatshield and the muffler or pipe. Leave it for an hour to set. No more rattling. Have been using this stuff for decades, particulary on exhaust gaskets, and it works a treat. |
|||
| Top | |
|||
| winman |
|
|||
|
Quote: Get some silicone.... must be the roofing stuff (not the coloured bathroom version). Squirt the silicone in between the heatshield and the muffler or pipe. Leave it for an hour to set. No more rattling. Have been using this stuff for decades, particulary on exhaust gaskets, and it works a treat. never thought of that, sounds like ill be going down to bunnings later. im just hoping ive actually got enough room under the car to pull the exhaust out (car will be about 30cm of the ground)
_________________ BA XR6 |
|||
| Top | |
|||
| hans hartman |
|
||
|
winman wrote: Quote: Get some silicone.... must be the roofing stuff (not the coloured bathroom version). Squirt the silicone in between the heatshield and the muffler or pipe. Leave it for an hour to set. No more rattling. Have been using this stuff for decades, particulary on exhaust gaskets, and it works a treat. never thought of that, sounds like ill be going down to bunnings later. im just hoping ive actually got enough room under the car to pull the exhaust out (car will be about 30cm of the ground) suck it in and get under it,or jack the side up and lever the pipe down, and goo it.
_________________ R.I.P HANS HARTMAN |
||
| Top | |
||
| winman |
|
|||
|
turns out the plastic fuel tank is actually behind the part of the heat shield i wanted to remove, so removing that was a no go zone. ive fixed the problem, used contact and high temp silicon to glue the heat shield to itself or the body pannels, no more rattle
 .... for now
_________________ BA XR6 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 82 guests |
