|
| Pulco |
|
||
|
Just wana know wats the biggest ppl have opened the exhuat ports to...
at them moment they are stock which is about 33mm...i want to open the up to suit my extractors which is 43mm just dont know whether there will be enuff "meat" outside if i do open them that far as i dont want to crack them with the heat expansion... any info would be great
_________________
|
||
| Top | |
||
| cjh |
|
|||
|
What brand of extractors do you have? Are they 43mm inside the pipe?
Usually, the std Ford exh port on 3.9/4.0, is smaller than the OE gasket anyway, approx 2-3mm smaller all round. If you take it out that far, you may risk loosing some the ability to transfer heat away from the exh port surrounding. Its only a thought.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| stockstandard |
|
|||
|
My exhaust ports are around 35mm. I dont see much point in going bigger.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| Pulco |
|
||
|
cjh wrote: What brand of extractors do you have? Are they 43mm inside the pipe?
Usually, the std Ford exh port on 3.9/4.0, is smaller than the OE gasket anyway, approx 2-3mm smaller all round. If you take it out that far, you may risk loosing some the ability to transfer heat away from the exh port surrounding. Its only a thought. yea well thats it...thats why i dont wana take too much out maybe just a couple of mm... they are pacemakers not the comp ones mite go and steal a flapper wheel from work and just give them a polish
_________________
|
||
| Top | |
||
| cjh |
|
|||
|
When I did mine, I used the OE tin gasket as a template, scribed a line around, then centre popped it, so to make the line clean & clear. Then used a die-grinder with an alloy burr, an egg shaped one, then use a flapper wheel, 120 grit. Take your time and be patient. as the saying goes, " all good things come to those who wait".
Good luck.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| old_mate |
|
|||
|
reckon it would be of much benefit? i havent seen a Falcon head in ages, but i would have though match porting to the headers would be a bit of a waste unless you were going to do the whole port and drop in larger valves
_________________ too many rabbits in china |
|||
| Top | |
|||
| Slick |
|
|||
|
You end up with not enough mating surface & it'll most likely cause exhaust leaks between the exhaust port & headers, if the header primaries start to warp.
_________________ Mind f**k!!! it works on feeble minded ignorant sheeples... there's plenty of em on this site... some are very intelligent but by god they are so thick!!! Pakrat wrote: You can buy them seppertly
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 94 guests |
