This afternoon I'll be fitting extractors to my BA XR6, and tomorrow an exhaust shop will be welding up my high flow cat to fit

Before I get too carried away tonight, just want to make sure the original header bolts that I will be taking out are going to be suitable for the extractors too? (Pacemaker PH4490).

Also, the exhaust shop recommended I use the original gasket with the gasket goo stuff, and add spring washers... anyone have any opinion on this?

Thanks!

I would recommend this also,

and as for the bolts? do you know if the ones i take out will be fine for the extractors?

Well, they seemed to work ok, so I'm guessing they'll be fine...

I added "Maniseal" to both sides of the gasket and added spring washers...

Cat to be fitted today by a local exhaust shop... it was a loud drive there with no exhaust haha

Can't wait to pick it up

Thanks Froudey.

--- Brady