|
| EF_wanabe |
|
||
|
SWC wrote: Engine side the Cat is 2.5". Rear of the cat is 2.25". As I said get a 3 bolt 2.5" flange and gasket to suit to bolt to the Extractors. This matches the flange on the extractors. 2.5" is the right size so lets say if we dont get the bottom flange to extractor's there quite common to buy ? |
||
| Top | |
||
| SWC |
|
||
|
EF_wanabe wrote: SWC wrote: Engine side the Cat is 2.5". Rear of the cat is 2.25". As I said get a 3 bolt 2.5" flange and gasket to suit to bolt to the Extractors. This matches the flange on the extractors. 2.5" is the right size so lets say if we dont get the bottom flange to extractor's there quite common to buy ? Any respectable Exhaust shop will have 2 bolt, 3 bolt and 4 bolt flanges of varying pipe sizes. |
||
| Top | |
||
| EF_wanabe |
|
||
|
SWC wrote: EF_wanabe wrote: SWC wrote: Engine side the Cat is 2.5". Rear of the cat is 2.25". As I said get a 3 bolt 2.5" flange and gasket to suit to bolt to the Extractors. This matches the flange on the extractors. 2.5" is the right size so lets say if we dont get the bottom flange to extractor's there quite common to buy ? Any respectable Exhaust shop will have 2 bolt, 3 bolt and 4 bolt flanges of varying pipe sizes. ahhh nice nice most probably would cost an arm and a leg |
||
| Top | |
||
| SWC |
|
||
|
Cost me from $6.00 to $12.00 depending on Size and number of bolts.
|
||
| Top | |
||
| EF_wanabe |
|
||
|
SWC wrote: Cost me from $6.00 to $12.00 depending on Size and number of bolts. ahh lucky i threw up the biggest fuss for the bottom piece of my extractors where the 02 sensor went into |
||
| Top | |
||
| SWC |
|
||
|
The part you are talking about is part of the Genie Exractors. You won't get that flange at most exhaust shops. 2 totaly different types of flanges.
|
||
| Top | |
||
| EF_wanabe |
|
||
|
SWC wrote: The part you are talking about is part of the Genie Exractors. You won't get that flange at most exhaust shops. 2 totaly different types of flanges. ahh my mistake hmmm should i go 3" on my EA with only 2 mufflers ? |
||
| Top | |
||
| SWC |
|
||
|
You don't need a 3" exhaust on a 4.0L unless it has massive work or is Turbo. 2.5" is quite sufficient.
|
||
| Top | |
||
| EF_wanabe |
|
||
|
SWC wrote: You don't need a 3" exhaust on a 4.0L unless it has massive work or is Turbo. 2.5" is quite sufficient. thought so , its just at pick a part the lady likes me , and i can get it for $50 , its stainless steel that's why i thought i asked i sent you a pm , need to ask you something about your weekend |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google [Bot] and 89 guests |