|
| 4LEDboy |
|
|||
|
Hello there
Before I go ahead and and fit these injectors I want to know if there is any special way to do this so I don't damage them! Should I replace the O-rings? and I noticed there are two slots in the neck of the au injectors for the clips to hold on to, which one of these should be used? I'm going to be using an adjustable fuel regulator aswell, how do I go setting the pressure (350kpa) before first startup? Cheers!
_________________ Adelaide Motorplex < Click on it! You know you want too! Quote: Thats not the point *a**hole
|
|||
| Top | |
|||
| Shortshift |
|
|||
|
Unless the O-rings are damaged, they'e probably OK to reuse. Use a smear of motor oil or Vaseline on the O-rings before you install each injector. The outer slot is where the clip goes to hold the injector to the fuel rail. It's easier to install the injectors in the fuel rail first.
Are the injectors recoed, or secondhand (eg. from the wreckers)?
_________________ AU2 XR8 with Raptor VL, ported Yella Terra GT40P heads, Scorpion 1.6 RRs, XE264HR-14 Comp Cam, ceramic coated Hurricane Headers, 60lb injectors, Walbro 255, 200cfi cats, 3" exhaust & Snow Performance water methanol injection |
|||
| Top | |
|||
| 4LEDboy |
|
|||
|
Yeah they are out of my AU motor, I'm fitting the log manifold
_________________ Adelaide Motorplex < Click on it! You know you want too! Quote: Thats not the point *a**hole
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 63 guests |
