|
| toby |
|
||
|
can anyone tell me how a professional machines a flywheel. like do they grind them on a special grinder or can it be done on a lathe?
im a fitter+turner/machinist and a mate wants to know if i can machine his ef flywheel for him. |
||
| Top | |
||
| tickford_6 |
|
||
Posts: 6449 Joined: 11th Nov 2004 |
they are ground with a stone.
but i've seen them done on a lathe befor. |
||
| Top | |
||
| Slick |
|
|||
|
heres something I've cut & paste from the internet. better of taking it to a specialist, that way they can lighten & balance it. most probably re-harden chemically, heat or shot peen.
FLYWHEEL MACHINING Flywheel resurfacing is critical to clutch performance. It is extremely important to restore the proper step dimension when applicable. Unfortunately there is no specification for maximum machining of a flywheel. The amount of material a flywheel is machined can vary anywhere from .005 to .050 of an inch. depending on condition. Removing too much material from the flywheel may cause release problems. As the overall thickness of a flywheel is reduced, the clutch set up geometry is changed. In fact, the clutch assembly is moved further away from the release bearing. Flywheel shims are now available to solve this problem. We DO NOT recommend this procedure because: (A) The starter drive will not engage the ring gear properly, and (B) Use of flywheel shims could encourage installation of a flywheel that is too thin. Lack of structural integrity may cause a "thin" flywheel to explode.
_________________ Mind f**k!!! it works on feeble minded ignorant sheeples... there's plenty of em on this site... some are very intelligent but by god they are so thick!!! Pakrat wrote: You can buy them seppertly
|
|||
| Top | |
|||
| Bluexr6 |
|
||
|
then how many times can you machine a flywheel before it needs replacing??
|
||
| Top | |
||
| Slick |
|
|||
|
^you only need to machine it once.
cost around $45- $60 to machine, don't know the cost for the extra.
_________________ Mind f**k!!! it works on feeble minded ignorant sheeples... there's plenty of em on this site... some are very intelligent but by god they are so thick!!! Pakrat wrote: You can buy them seppertly
|
|||
| Top | |
|||
| GTBob |
|
|||
|
Bluexr6 wrote: then how many times can you machine a flywheel before it needs replacing??
Depends on how much you take off each tume 
_________________ Rotten Old Revhead!!! XW GTHO + EF ex cop car (exractors 2.5 cat back zorst !6" Simmons K&N +airbox mods Lowered with Bilstein shocks+Whiteline Bars NEXT THING Swap HO for GTP or Ferrari! |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google [Bot], Google Adsense [Bot] and 98 guests |
