|
| ryanalder |
|
||
|
hey all can i change my fuel filter with normal spanners?and alot of ppl say the fuel line bolts are that tight sum times u simply can get the filter of?and to de pressurize the system do u simple take out the fuel pump fuse from the box in the enginge bay?i never done a fuel filter change before lol
|
||
| Top | |
||
| ryanalder |
|
||
|
forgot to say it was on an au
|
||
| Top | |
||
| cjh |
|
|||
|
When you pull the fuse, start and run till it dies. Yes, use a 14mm Flare-nut spanner on the nut, and a 19mm spanner to hold the filter still, and if you have strong fingers, push in, then pinch the fitting on the other end and pull.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| twr7cx |
|
|||
|
Fork out for a flare nut spanner, the amount of people who ruin them using normal open enders. If your going to do your own maintenance get the right tools.
|
|||
| Top | |
|||
| Papa Smurf |
|
||
|
twr7cx wrote: Fork out for a flare nut spanner, the amount of people who ruin them using normal open enders. If your going to do your own maintenance get the right tools. SO bloody right, I have a set I invested in about 20 years ago. Best money I ever spent. |
||
| Top | |
||
| dahayes |
|
||
|
i just did mine with vice grips seemed to work quite well.make sure you do them up nice and tight when ur finished
|
||
| Top | |
||
| ryanalder |
|
||
|
put the fuel filter on today started it up let it idle for bout ten mins couldnt see any leaks?
should be fine yea |
||
| Top | |
||
| Krytox |
|
|||
|
stick with Ryco filters also.
I've found valvoline/cooper and other brands all tend to be steel filters, whereas Ryco still make them out of alloy. The fuel lines and threads are alloy and when using a softer filter they seal better than the steel with LESS tightening.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| twr7cx |
|
|||
|
dahayes wrote: i just did mine with vice grips seemed to work quite well.make sure you do them up nice and tight when ur finished Exactly what I was getting at above... It's not hard to end up damaging it with vice grips, and they leave marks etc. |
|||
| Top | |
|||
| ToranaGuy |
|
|||
|
A set of cheap flare or pipe spanners at Bunnings or Super Cheap isn't very expensive. I bought myself a set from Bunnings and it was one of the best purchases I've ever made. Bought it to do the fuel filter on the EB, and I've since done a number of jobs on brake lines & gas lines with them. Without damaging the nuts at all.
A very worth while investment for the home workshop! Cheers ToranaGuy
_________________ I am the ToranaGuy!|74 Lh Torana Turbo|78 Hz PanelVan|86 Mighty Boy Ute|93 EB2 Ghia,GT Mockup,5spd,LPGI,Full Leather|2 x EB Xr8 5spd's|FS [VIC]: Wrecking - Eb XR8 - Parts available |Build Thread|Ebay Items - Ford Parts| |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 140 guests |
