|
| gutza |
|
||
|
Greetings All
I have an EA with 3.9 mpfi. Going to take the head off for a good clean and strip, check the valves, springs etc before putting a stage 1 cam in. Two questions: 1. Is the AU gasket OK for the 3.9?? 2. I've read elsewhere that you should run straight water for a day or two to help the head gasket seal before putting in coolant. Does this apply to the AU gasket as its metal ?? ( in a sandwich ?? ). Thanks guys. |
||
| Top | |
||
| arm79 |
|
|||
|
1. AU Gasket will be fine
2. Never heard of that theory before. I think everyone has put coolant straight into the engines after a head gasket swap and has worked fine for many 1000's of km. Its how I have done mine, and its been all good. Good luck with the work. 
|
|||
| Top | |
|||
| falcon4250 |
|
|||
|
Its a lot of work however have fun.
_________________ #### Was formerly falcon4250 (My old EA) ####
|
|||
| Top | |
|||
| eb_guy888 |
|
||
|
AU gasket all fine
mechanics usually put coolent straight in afterwards, dont have to run water for a few days as far as I know and ive replaced 2 heads |
||
| Top | |
||
| falcon4250 |
|
|||
|
also use AU headbolts as they have better robust threads than your standard EA headbolts.
_________________ #### Was formerly falcon4250 (My old EA) ####
|
|||
| Top | |
|||
| smiley235 |
|
|||
|
one tip, BE CAREFUL NOT TO SNAP THE TIMING CHAIN GUIDE WHEN YOUR REMOVING THE HEAD, THEY ARE AS BRITTLE AS A TWIG.
_________________ 178.3 rwkw
|
|||
| Top | |
|||
| The Dog |
|
|||
|
When refitting the headbolts put a dollop of oil under the heads. This stops the bolts galling up on the head and giving false readings on your torque wrench. I have always run water for the first week but I'd never heard of it being used to help gasket seal. I always did it so I didn't waste coolant if there was any sort of leak
_________________ You'll ride a black tornado across the western sky
|
|||
| Top | |
|||
| naughtyfalcon |
|
|||
|
i run straight water for a week for the same reason xhute0 does,,it's not cheap.
also use a thread sealer on the head bolts,,like graphite paste.
_________________
|
|||
| Top | |
|||
| gutza |
|
||
|
Thanks for all the help and advice guys.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 88 guests |
